[U-Boot] [PATCH v3] usb: gadget: Fix data aborts during USB ethernet boot

[Marek Vasut <marex@denx.de>]

Dear Joel Fernandes,

> As seen on GCC 4.6 Linaro compiler, control_req buffer is not aligned
> on 4 byte boundaray causing data aborts in eth_setup -> conf_buf
> during dhcp boot over usb_ether. Fix the issue my aligning control_req
> buffer using DEFINE_CACHE_ALIGN_BUFFER.
> 
> Tested on am335x_evm platform (beaglebone).
> Applies on 2013.10-rc1 branch.
> 
> Cc: Tom Rini <trini@ti.com>
> Cc: Marek Vasut <marex@denx.de>
> Signed-off-by: Joel Fernandes <joelf@ti.com>
> ---
> v2 changes:
>  - Using DEFINE_CACHE_ALIGN_BUFFER macro for the alignment.
>  - Also fixed alignment for status_req.
> 
> v3 changes:
>  - Adjusted commit message for v2 change.
> 
>  drivers/usb/gadget/ether.c | 5 +++--
>  1 file changed, 3 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/usb/gadget/ether.c b/drivers/usb/gadget/ether.c
> index 579893c..700d5fb 100644
> --- a/drivers/usb/gadget/ether.c
> +++ b/drivers/usb/gadget/ether.c
> @@ -849,9 +849,10 @@ static struct usb_gadget_strings	stringtab = {
>  };
> 
>  /*========================================================================
> ====*/ -static u8 control_req[USB_BUFSIZ];
> +DEFINE_CACHE_ALIGN_BUFFER(u8, control_req, USB_BUFSIZ);
> +
>  #if defined(CONFIG_USB_ETH_CDC) || defined(CONFIG_USB_ETH_RNDIS)
> -static u8 status_req[STATUS_BYTECOUNT] __attribute__ ((aligned(4)));
> +DEFINE_CACHE_ALIGN_BUFFER(u8, status_req, STATUS_BYTECOUNT);
>  #endif

Applied, thanks

Best regards,
Marek Vasut