From mboxrd@z Thu Jan 1 00:00:00 1970 From: Tom Rini Date: Tue, 22 Apr 2014 11:41:22 -0400 Subject: [U-Boot] [PATCH v2 7/8] cmd_mmc.c: Add bootbus mmc sub-command In-Reply-To: References: <1391117520-21868-1-git-send-email-trini@ti.com> <1391117520-21868-7-git-send-email-trini@ti.com> Message-ID: <20140422154122.GD22182@bill-the-cat> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Fri, Apr 18, 2014 at 11:25:23AM +0200, Michael Trimarchi wrote: > Hi Tom > > On Thu, Jan 30, 2014 at 10:31 PM, Tom Rini wrote: > > Add a bootbus sub-command to the mmc command to allow for setting > > the boot_bus_width, reset_boot_bus_width and boot_mode fields of > > BOOT_BUS_WIDTH (EXT_CSD[177]). > > > > Signed-off-by: Tom Rini > > --- > > Can I ask if does it work even for OMAP4 device? > So can I flash on boot0 and let omap4 bootrom to load from that? In theory, yes. I don't have hardware around in that exact setup, but if the OMAP4 TRM talks about booting from the boot partition then yes, this should let you set all the right bits. -- Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: not available Type: application/pgp-signature Size: 836 bytes Desc: Digital signature URL: