[U-Boot] [PATCH v2] imx: ddr: Move mx6q_4x_mt41j128.cfg to mx6sabresd board dir

[Wolfgang Denk <wd@denx.de>]

Dear Otavio,

In message <CAP9ODKonaZ9v76WAdd4k7or_kUWF=ATTLf+-DrqgQYVgKbt8Bg@mail.gmail.com> you wrote:
> 
> > But in the next sentence you state that this very file is also used by
> > another board (cgtqmx6qeval) - so apparently it is NOT a board
> > specific file.  Actually this makes even more sense to me, as I would
> > expect that the file is more specific to the DDR type than to the
> > board.
> >
> > So why exactly do you think it would be better to move this into a
> > board specific place?
> 
> All the calibration has been done by Freescale and for the SABRE SD
> board. This is not guarantee it works in other boards, neither
> expected. Congatec opted to include this file but it is their choice
> and moving to the board file makes it more evident.

This may be all true, but nevertheless this is NOT board specific
code.  And you can already see it being reused by other boards, so the
most natural way to handle it is to factor it out into a common
directory.  And actually this is what we had before.

If we are going to change code, we should have a good reason for such
a change, like fixing bugs, adding features, or cleaning up.  What
exactly is that good reason here?  Moving code used by more than one
board from a common place to a board-specific one make things worse,
not better.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Until you walk a mile in another man's moccasins, you  can't  imagine
the smell.