[U-Boot] [PATCH v3 1/3] usb:ehci-mx6 add board_usb_phy_mode function

[Marek Vasut <marex@denx.de>]

On Friday, November 07, 2014 at 12:03:30 PM, Peng Fan wrote:

[...]

> >> @@ -160,7 +174,7 @@ static int usb_phy_enable(int index, struct usb_ehci
> >> *ehci) val |= (USBPHY_CTRL_ENUTMILEVEL2 | USBPHY_CTRL_ENUTMILEVEL3);
> >> 
> >>   	__raw_writel(val, phy_ctrl);
> >> 
> >> -	return val & USBPHY_CTRL_OTG_ID;
> >> +	return board_usb_phy_mode(index);
> > 
> > This should be called from ehci_hcd_init() right after usb_phy_enable().
> > Afterall, the mode detection has nothing to do with the PHY enabling.
> 
> This back to what I did in patch v2. right after usb_phy_enable(), just
> paste that piece of code here:
> 
> The weak function:
> +int __weak board_ehci_usb_mode(int index, enum usb_init_type *type)
> +{
> +       return 0;
> +}
> +
> 
>          type = usb_phy_enable(index, ehci) ? USB_INIT_DEVICE :
> USB_INIT_HOST;
> 
> +       board_usb_phy_mode(index, &type);
> +

The usb_phy_enable() should not return the PHY mode at all though.
It should be the board_usb_phy_mode() which adjusts the PHY type.
The usb_phy_enable() should return just a success/failure return
value.

> What need to do is to let board can modify the `type` like following:
> +int board_usb_phy_mode(int port, enum usb_init_type *type)
> +{
> +	if (port == 1)
> +       /* port1 works in HOST Mode */
> +       	*type = USB_INIT_HOST;
> +
> +       return 0;
> +}
> +
> This is the way that I did in patch v2. If this is fine, I'll resent
> this patch set.

It should really explicitly set it, not modify it, see above.

[...]