[U-Boot] [PATCH v6 0/5] add i.MX6 thermal sensor driver

[Albert ARIBAUD <albert.u.boot@aribaud.net>]

Hello nitin.garg at freescale.com,

On Fri, 14 Nov 2014 14:13:02 -0600, nitin.garg at freescale.com
<nitin.garg@freescale.com> wrote:
> From: Nitin Garg <nitin.garg@freescale.com>
> 
> This patch set adds i.MX6 thermal sensor driver
> and enables it for mx6sabre boards. Also adds
> various anadig bit definitions as required for
> upcoming drivers.
> 
> Changes in v6:
> -Aligned imx thermal driver macro defines with kernel
> 
> Changes in v5:
> -Don't modify the copyright of cpu.c and crm_regs.h file
> 
> Changes in v4:
> -Added imx6 thermal sensor as a driver
> -Renamed the config define to be more meaningful
> -Move the clock code to clock.c
> -Reusing ocotp driver for reading fuse
> -Fix check for calibration fuse not programmed
> -Aligned the slope computation with kernel
> -Added Anadig register defines as seperate commit
> 
> Changes in v3:
> -adds the mx6 thermal driver support
> -adds the mx6 thermal support to mx6sabresd board.
> 
> Changes in v2:
> -run checkpatch and fix reported issues
> 
> Nitin Garg (4):
>   mx6: clock: Add api to enable pll3
>   mx6: thermal: Add i.MX6 CPU thermal sensor support
>   mx6: thermal: Check cpu temperature via thermal sensor
>   mx6: thermal: Enable thermal sensor for mx6 sabre boards.

So, is it 5 as the cover letter says, or 4 as the patches say? If
actually 4 and only the cover letter is wrong, then there's no need to
repost. If actually 5, then please repost them all, renumbered
accordingly.

Amicalement,
-- 
Albert.