[U-Boot] U-Boot stuck after relocation attempt on MX51 board

[Albert ARIBAUD <albert.u.boot@aribaud.net>]

Hello Beno?t,

On Thu, 26 Feb 2015 00:56:00 +0100, Beno?t Th?baudeau
<benoit.thebaudeau.dev@gmail.com> wrote:
> Dear Dave Kucharczyk,
> 
> On Wed, Feb 25, 2015 at 11:08 PM, DaveKucharczyk
> <david.kucharczyk@gmail.com> wrote:
> > Fabio Estevam-2 wrote
> >> Also, you said that your 512MB board version works fine, but the 256MB
> >> fails.
> >>
> >> I suppose you are using two different binaries for each board, right?
> >> You can't have a single binary for the two boards, unless you use the
> >> SPL approach.
> >
> > Fabio, we use one binary. It has runtime memory discovery via gpio's
> > (resistor reads). DRAM size is reported correctly from both boards. It just
> > hangs on the 256MB board.
> >
> > We do not have SPL setup.
> 
> You should try with 2015.01 as Fabio suggested.
> 
> Also, check the CONFIG_SYS_TEXT_BASE of your board. From your log, I'm
> wondering if it's not set too high, resulting in an overlap of the
> pre- and post-relocation addresses occupied by your binary in the
> 256-MiB case.

/me wonders whether we should not add a test for this situation, with
a conspicuous error message on the console stating that relocation will
probably fail due to overlap.

> Best regards,
> Beno?t

Amicalement,
-- 
Albert.