[U-Boot] [PATCH] mtd: sf: Add CONFIG_SPI_N25Q256A_RESET for software-reset

[Marek Vasut <marex@denx.de>]

On Friday, May 01, 2015 at 04:49:37 PM, Pavel Machek wrote:
> On Fri 2015-05-01 16:24:45, Marek Vasut wrote:
> > On Friday, May 01, 2015 at 11:01:09 AM, Pavel Machek wrote:
> > > diff --git a/drivers/mtd/spi/sf_probe.c b/drivers/mtd/spi/sf_probe.c
> > > index 201471c..f7cfbd9 100644
> > > --- a/drivers/mtd/spi/sf_probe.c
> > > +++ b/drivers/mtd/spi/sf_probe.c
> > > @@ -347,6 +348,36 @@ int spi_flash_probe_slave(struct spi_slave *spi,
> > > struct spi_flash *flash) }
> > > 
> > >  	}
> > > 
> > > +#ifdef CONFIG_SPI_N25Q256A_RESET
> > 
> > Should be CONFIG_SPI_MICRON_RESET, since other parts which can also be
> > used would have similar issue.
> 
> I'm pretty sure some Micron parts use different interface.

Which ones ?

> > It'd be nice if you
> > added diffstat into your patches as it makes things easier during
> > review.
> 
> Yes, it also makes patch harder to create (as it is tricky to
> hand-edit the patches)

git format-patch automatically inserts the diffstat for you.

> , and having diffstat for a patch that fits on a
> screen is just stupid.

It's a 2-line diffstat for this patch. If you get a 1-screen big
diffstat, then your patch is most likely wrong.

> > > +	 * { "n25q256a", INFO(0x20ba19, 0, 64 * 1024,  512,
> > > +	 *    SECT_4K | SHUTDOWN_3BYTE) },
> > > +	 *
> > > +	 * Add SHUTDOWN_3BYTE here.
> > > +	 */
> > > +	ret = spi_flash_cmd(spi, CMD_RESET_ENABLE, NULL, 0);
> > > +	if (ret) {
> > > +		printf("SF: Failed issue reset command\n");
> > 
> > I thought this was just a reset-enable command. If this command
> > fails, user won't be able to tell which of these two failed, so
> > it's a bad idea to use the same error message for both.
> 
> Ok.
> 									Pavel

Best regards,
Marek Vasut