[U-Boot] [PATCH 10/11] usb: ehci-vf: Add weak function for board specific initialisation

[Marek Vasut <marex@denx.de>]

On Monday, May 18, 2015 at 08:52:59 PM, maitysanchayan at gmail.com wrote:
> Hello Marek,

Hi!

> On 15-05-18 19:09:58, Marek Vasut wrote:
> > On Monday, May 18, 2015 at 03:06:28 PM, Bhuvanchandra DV wrote:
> > > From: Sanchayan Maity <maitysanchayan@gmail.com>
> > > 
> > > Add a weak function board_ehci_hcd_init which can be used by the board
> > > file for board specific initialisation.
> > > 
> > > Signed-off-by: Sanchayan Maity <maitysanchayan@gmail.com>
> > 
> > Acked-by: Marek Vasut <marex@denx.de>
> > 
> > What I do not like is that you're sending a patch series which affects
> > multiple subsystems and which contains patches which should go through
> > multiple trees. Yet, you submit it all in one huge series.
> 
> If required I can send in the last two patches affecting the USB
> susbsystem later once the rest of the patchset gets merged, if this is
> not acceptable?.
> 
> Since these last two were dependent on the GPIO patches I thought
> perhaps it is better that they go along with the GPIO patches as a
> coherent whole.

I think if there's no oposition, just push this all via u-boot-imx .
I don't plan to block it, but subsystem stuff should usually go though
subsystem trees.

Best regards,
Marek Vasut