[U-Boot] [PATCH v2 2/4] usb: s3c-otg: support 8-bit interface

[Lukasz Majewski <l.majewski@samsung.com>]

Hi Steve,

> 
> 
> On 15-07-07 06:27 AM, Lukasz Majewski wrote:
> > Hi Steve,
> >
> >> Signed-off-by: Steve Rae <srae@broadcom.com>
> >> ---
> >>
> >> Changes in v2: None
> >>
> >>   drivers/usb/gadget/s3c_udc_otg.c | 4 ++++
> >>   1 file changed, 4 insertions(+)
> >>
> >> diff --git a/drivers/usb/gadget/s3c_udc_otg.c
> >> b/drivers/usb/gadget/s3c_udc_otg.c index 7a2d1e7..2e3b4f7 100644
> >> --- a/drivers/usb/gadget/s3c_udc_otg.c
> >> +++ b/drivers/usb/gadget/s3c_udc_otg.c
> >> @@ -414,7 +414,11 @@ static void reconfig_usbd(struct s3c_udc *dev)
> >>   		|0<<7		/* Ulpi DDR sel*/
> >>   		|0<<6		/* 0: high speed utmi+, 1:
> >> full speed serial*/ |0<<4		/* 0: utmi+, 1:ulpi*/
> >> +#ifdef CONFIG_USB_GADGET_PHY_8_BIT
> >> +		|0<<3		/* phy i/f  0:8bit, 1:16bit*/
> >> +#else
> >>   		|1<<3		/* phy i/f  0:8bit,
> >> 1:16bit*/ +#endif
> >
> > Is your board using also host phy? As fair as I remember, the upper
> > 8 bits are for host interface.
> Hi Lukasz,
> Are you suggesting that we define this as a 16-bit interface, and
> then only use the upper 8-bits (to achieve the 8-bit interface)?
> Please clarify, Thanks Steve

As fair as I remember we use lower 8 bits for device PHY and upper for
host.

Your board (with this Synopsys IP) should work with 16 bits as well.

> >
> >
> >>   		|0x7<<0;	/* HS/FS Timeout**/
> >>
> >>   	if (dev->pdata->usb_gusbcfg)
> >
> > Despite my above question:
> >
> > Acked-by: Lukasz Majewski <l.majewski@samsung.com>
> >



-- 
Best regards,

Lukasz Majewski

Samsung R&D Institute Poland (SRPOL) | Linux Platform Group