[U-Boot] [PATCHv4 0/3] drivers/ddr/altera: Add the DDR controller driver for SoCFPGA

[Marek Vasut <marex@denx.de>]

On Monday, July 20, 2015 at 03:40:00 PM, Dinh Nguyen wrote:
> On 7/17/15 3:22 PM, Marek Vasut wrote:
> > On Friday, July 17, 2015 at 09:58:20 PM, Dinh Nguyen wrote:
> >> On 07/12/2015 02:50 PM, Marek Vasut wrote:
> >>> On Friday, June 26, 2015 at 10:01:47 PM, Marek Vasut wrote:
> >>>> On Friday, June 26, 2015 at 06:43:13 PM, Marek Vasut wrote:
> >>>>> On Wednesday, June 03, 2015 at 05:52:47 AM,
> >>>>> dinguyen at opensource.altera.com
> >>>>> 
> >>>>> wrote:
> >>>>>> From: Dinh Nguyen <dinguyen@opensource.altera.com>
> >>>>>> 
> >>>>>> Hi,
> >>>>>> 
> >>>>>> This is v4 of the patch series that adds the DDR controller driver
> >>>>>> for Altera's SoCFPGA platform.
> >>>>>> 
> >>>>>> v4:
> >>>>>> - Further cleanup by removing comments that do not apply for
> >>>>>> Cyclone5. - Removed more unused functions
> >>>>>> 
> >>>>>> Thanks,
> >>>>> 
> >>>>> I applied this to u-boot/master and tried building for
> >>>>> socfpga_cyclone5, this is what I'm getting after I fixed these
> >>>>> patches to actually apply to u-boot/master (there was a minor
> >>>>> conflict in Makefile):
> >>>>> 
> >>>>> drivers/ddr/altera/sdram.c:11:35: fatal error:
> >>>>> asm/arch/sdram_config.h: No such file or directory
> >>>>> 
> >>>>>  #include <asm/arch/sdram_config.h>
> >>>> 
> >>>> OK, these files were misplaced by the patch. Now I got it to compile,
> >>>> only to see that when I try to init DRAM on sockit using those, PHY
> >>>> calibration fails (run_mem_calibrate() returns 1).
> >>>> 
> >>>> btw. I also think sdram_config.h should go into board/altera/ instead
> >>>> .
> >>> 
> >>> Just a quick heads-up, I'm cleaning this and the SPL up. I got SoCkit
> >>> booting from SD/MMC and I'm over 50 patches now. I'll submit them when
> >>> I'm done with this. I'd like to avoid merge conflicts now, so please
> >>> wait for my submission if possible.
> >> 
> >> So you want me to wait regarding the SDRAM patches?
> > 
> > Hi,
> > 
> > yeah, I have some insane amount of cleanup patches and fixes already. I
> > will post them once I'm done. What I am sorely missing is the UniPHY
> > register interface documentation, it looks like that is not public, so
> > I don't exactly know if what sequencer.c does is really correct.
> > Sometimes I have serious doubts about that too . Can you give me the
> > documentation please ?
> 
> Have you seen this link[1]?

Yes, but that is by far not all of the registers used in the sequencer.c,
is it ?

> Dinh
> [1] https://documentation.altera.com/#/00013681-AA$NT00067543

Best regards,
Marek Vasut