[U-Boot] [PATCH 4/4] imx: mx6ul_14x14_evk add ENET support

[Peng Fan <b51431@freescale.com>]

Hi Fabio,
On Mon, Aug 03, 2015 at 07:39:33AM -0300, Fabio Estevam wrote:
>On Mon, Aug 3, 2015 at 7:06 AM, Peng Fan <Peng.Fan@freescale.com> wrote:
>
>> +int board_eth_init(bd_t *bis)
>> +{
>> +       int ret;
>> +
>> +       setup_iomux_fec(CONFIG_FEC_ENET_DEV);
>> +
>> +       ret = fecmxc_initialize_multi(bis, CONFIG_FEC_ENET_DEV,
>> +               CONFIG_FEC_MXC_PHYADDR, IMX_FEC_BASE);
>> +       if (ret)
>> +               printf("FEC%d MXC: %s:failed\n", CONFIG_FEC_ENET_DEV, __func__);
>> +
>> +       return 0;
>
>You are returning 0 even if there is an error.
>
>You could simply do:
>
>       return fecmxc_initialize_multi(bis, CONFIG_FEC_ENET_DEV,
>               CONFIG_FEC_MXC_PHYADDR, IMX_FEC_BASE);

Thanks, will fix in V2.

>
>> +}
>> +
>> +static int setup_fec(int fec_id)
>> +{
>> +       struct iomuxc *const iomuxc_regs = (struct iomuxc *)IOMUXC_BASE_ADDR;
>> +       int ret;
>> +
>> +       if (0 == fec_id) {
>
>Can you do if (!fec_id)?
Why need to change to (!fec_id)? I do not see benifits to use (!fec_id).

Regards,
Peng.
--