[U-Boot] [PATCH] i2c: adding driver for pxa27x, pxa3xx, pxa25x

[Marek Vasut <marex@denx.de>]

On Sunday, August 16, 2015 at 02:34:20 AM, Marcel Ziswiler wrote:
> On Wed, 2015-08-12 at 13:43 -0500, Andrew Ruder wrote:
> > Cc: Marek Vasut <marex@denx.de>
> > Cc: Heiko Schocher <hs@denx.de>
> > Signed-off-by: Andrew Ruder <andrew.ruder@elecsyscorp.com>
> > ---
> > 
> > This driver was written before the driver model stuff was really
> > around (or at
> > least based on a U-Boot version that only had very preliminary
> > support) so
> > there might be some older conventions in use here.  I have tested on
> > a PXA270
> > board running upstream master with this driver, however - so to some
> > extent
> > this all still works fine.  Let me know if things need to change to
> > be
> > accepted, and I'll try to find some time to update!
> 
> Apart from the missing commit message.
> 
> Signed-off-by: Marcel Ziswiler <marcel@ziswiler.com>

I think you're misunderstanding the meaning of a SoB line here, the SoB
line is a certificate of origin. You didn't write the driver and/or you
didn't make changes to it, so you don't place your certificate on it :)

> Tested-by: Marcel Ziswiler <marcel@ziswiler.com>

This one is of course good.

> Tested-on: Colibri PXA270 V1.2C, V1.2D, V2.2B, V2.4A on Colibri

Is this some kind of a newly invented tag ? :-)

> Evaluation Board V3.1A
> Note: While power I2C works on the older V1.2C version it does not seem
> to work on any of the newer ones but this might just be a pin muxing
> resp. missing pull up issue.

Very nice. Btw. how do you bootstrap those modules, do you use that OpenPXA
OBM or OBM2 or something else entirely ?

Best regards,
Marek Vasut