[U-Boot] [v3 1/4] spi: cadence_qspi: move trigger base configuration in init

[Marek Vasut <marex@denx.de>]

On Saturday, August 15, 2015 at 04:15:57 AM, Vikas Manocha wrote:
> No need to configure indirect trigger address for every read/write.
> 
> Signed-off-by: Vikas Manocha <vikas.manocha@st.com>
> ---
> 
> Changes in v3: added commit message & removed extra bracket.
> Changes in v2: Rebased to master
> 
>  drivers/spi/cadence_qspi_apb.c |    9 ++-------
>  1 file changed, 2 insertions(+), 7 deletions(-)
> 
> diff --git a/drivers/spi/cadence_qspi_apb.c
> b/drivers/spi/cadence_qspi_apb.c index d053407..b46e5fe 100644
> --- a/drivers/spi/cadence_qspi_apb.c
> +++ b/drivers/spi/cadence_qspi_apb.c
> @@ -534,6 +534,8 @@ void cadence_qspi_apb_controller_init(struct
> cadence_spi_platdata *plat)
> 
>  	/* Indirect mode configurations */
>  	writel((plat->sram_size/2), plat->regbase + CQSPI_REG_SRAMPARTITION);
> +	writel((u32)plat->ahbbase & CQSPI_INDIRECTTRIGGER_ADDR_MASK,
> +				plat->regbase + CQSPI_REG_INDIRECTTRIGGER);

Please drop this (u32) cast, it's misleading and problematic.

Best regards,
Marek Vasut