From mboxrd@z Thu Jan  1 00:00:00 1970
From: Marek Vasut <marex@denx.de>
Date: Fri, 21 Aug 2015 02:42:16 +0200
Subject: [U-Boot] [PATCH 1/2] arm: socfpga: mmc: Enable calibration for
	drvsel and smpsel
In-Reply-To: <55D671F4.8040706@opensource.altera.com>
References: <1439963690-2523-1-git-send-email-clsee@altera.com>
 <201508202359.20094.marex@denx.de> <55D671F4.8040706@opensource.altera.com>
Message-ID: <201508210242.16444.marex@denx.de>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

On Friday, August 21, 2015 at 02:33:56 AM, Dinh Nguyen wrote:
> On 8/20/15 4:59 PM, Marek Vasut wrote:
> > On Thursday, August 20, 2015 at 11:55:02 PM, Dinh Nguyen wrote:
> >> +CC: Simon Glass
> > 
> > Hi Dinh,
> > 
> >> On Thu, Aug 20, 2015 at 12:32 AM, Marek Vasut <marex@denx.de> wrote:
> >>> On Thursday, August 20, 2015 at 07:28:02 AM, Chin Liang See wrote:
> >>>> Hi,
> >>>> 
> >>>> On Wed, 2015-08-19 at 14:36 +0000, marex at denx.de wrote:
> >>>>> On Wednesday, August 19, 2015 at 10:21:17 AM, Chin Liang See wrote:
> >>>>>> Hi,
> >>>>> 
> >>>>> Hi again,
> >>>>> 
> >>>>>> On Wed, 2015-08-19 at 02:41 +0000, marex at denx.de wrote:
> >>>>>>> On Wednesday, August 19, 2015 at 07:54:50 AM, Chin Liang See wrote:
> >>>>>>>> Enable SDMMC calibration to determine the best setting for
> >>>>>>>> drvsel and smpsel. It will be triggered whenever there is
> >>>>>>>> a change of card frequency and bus width. This is to ensure
> >>>>>>>> reliable transmission between the controller and the card.
> >>>>>>>> 
> >>>>>>>> Signed-off-by: Chin Liang See <clsee@altera.com>
> >>>>>>>> Cc: Dinh Nguyen <dinguyen@opensource.altera.com>
> >> 
> >> I think there's something wrong with your git scripts, I did not get
> >> this email.
> > 
> > You're not getting quite a lot of email I think. Could it be that altera
> > has some issues with their mail system after some 300 patches went
> > through your mailbox ? You sure you're not being filtered ? :b
> 
> I would not be surprised if I was, but I don't think I am. Since I
> explicitly included my email address in the CC line on my earlier
> response, I am seeing the mail just fine now. My opensource.altera.com
> address was not even in the cc address line at all in any of the earlier
> emails.

Oh, I see, thank you for clarifying :)

Could it be that the ML itself is behaving in a funny way ? I saw this a
few times before too.

btw did you get my email about the IOCSR ?

Best regards,
Marek Vasut