[U-Boot] [PATCH 4/4] exynos: fix and cleanup do_sdhci_init()

[Lukasz Majewski <l.majewski@samsung.com>]

Hi Jaehoon,

> Hi,
> 
> On 09/23/2015 06:48 PM, Lukasz Majewski wrote:
> > Hi Lukasz,
> > 
> >> Hi Tobias,
> >>
> >>> The CD check is currently inverted. dm_gpio_get_value() returns
> >>> one when a card is detected. All other values (zero when there
> >>> is no card, or negative values for the internal errors) indicate
> >>> failure.
> >>>
> >>> Signed-off-by: Tobias Jakobi <tjakobi@math.uni-bielefeld.de>
> >>> ---
> >>>  drivers/mmc/s5p_sdhci.c | 20 +++++++++++---------
> >>>  1 file changed, 11 insertions(+), 9 deletions(-)
> >>>
> >>> diff --git a/drivers/mmc/s5p_sdhci.c b/drivers/mmc/s5p_sdhci.c
> >>> index 6be3609..bc04370 100644
> >>> --- a/drivers/mmc/s5p_sdhci.c
> >>> +++ b/drivers/mmc/s5p_sdhci.c
> >>> @@ -102,29 +102,31 @@ struct sdhci_host
> >>> sdhci_host[SDHCI_MAX_HOSTS]; 
> >>>  static int do_sdhci_init(struct sdhci_host *host)
> >>>  {
> >>> -	int dev_id, flag;
> >>> -	int err = 0;
> >>> +	int dev_id, flag, ret;
> >>>  
> >>>  	flag = host->bus_width == 8 ? PINMUX_FLAG_8BIT_MODE :
> >>> PINMUX_FLAG_NONE; dev_id = host->index + PERIPH_ID_SDMMC0;
> >>>  
> >>>  	if (dm_gpio_is_valid(&host->pwr_gpio)) {
> >>>  		dm_gpio_set_value(&host->pwr_gpio, 1);
> >>> -		err = exynos_pinmux_config(dev_id, flag);
> >>> -		if (err) {
> >>> +		ret = exynos_pinmux_config(dev_id, flag);
> >>> +		if (ret) {
> >>>  			debug("MMC not configured\n");
> >>> -			return err;
> >>> +			return ret;
> >>>  		}
> >>>  	}
> >>>  
> >>>  	if (dm_gpio_is_valid(&host->cd_gpio)) {
> >>> -		if (dm_gpio_get_value(&host->cd_gpio))
> >>> +		ret = dm_gpio_get_value(&host->cd_gpio);
> >>> +		if (ret != 1) {
> >>> +			debug("No card detected (%d)\n", ret);
> >>>  			return -ENODEV;
> >>> +		}
> >>>  
> >>> -		err = exynos_pinmux_config(dev_id, flag);
> >>> -		if (err) {
> >>> +		ret = exynos_pinmux_config(dev_id, flag);
> >>> +		if (ret) {
> >>>  			printf("external SD not configured\n");
> >>> -			return err;
> >>> +			return ret;
> >>>  		}
> >>>  	}
> >>>  
> >>
> >> Reviewed-by: Lukasz Majewski <l.majewski@samsung.com>
> >>
> > 
> > Sorry, I was too fast. I've read the whole thread and I can confirm
> > that your change would break Trats board.
> > ry
> > I hope that we will come up with proper solution.
> 
> We can use the "cd-inverted" property like linux-kernel.
> Then i think that all board based on exynos4412 can cover.
> how about?

I'm ok with this approach.

> 
> Best Regards,
> Jaehoon Chung
> 
> 
> > 
> 



-- 
Best regards,

Lukasz Majewski

Samsung R&D Institute Poland (SRPOL) | Linux Platform Group