From mboxrd@z Thu Jan 1 00:00:00 1970 From: Tom Rini Date: Mon, 28 Sep 2015 17:08:13 -0400 Subject: [U-Boot] [U-Boot, v2, 7/8] ARM: hikey: hi6220: Migrate over to DM_SERIAL and use UART3 by default. In-Reply-To: <1441918518-25629-8-git-send-email-peter.griffin@linaro.org> References: <1441918518-25629-8-git-send-email-peter.griffin@linaro.org> Message-ID: <20150928210813.GX22966@bill-the-cat> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Thu, Sep 10, 2015 at 09:55:17PM +0100, Peter Griffin wrote: > Use DM for the pl01x serial driver on hikey. Also allow UART0 or > UART3 to be chosen via Kconfig. > > By default we now output to UART3 as the latest version of ATF outputs > to this UART. Also UART3 comes out on the LS connector, as opposed to > UART0 which goes to a unpopulated header. > > As part of this change we also enable CONFIG_BOARD_EARLY_INIT_F and > call the pinmux configuration code for the UART. Before we were > relying on ATF having already configured the pin configuration. > > NB: Upstream Linux kernel doesn't yet support UART3, so serial console > will still be output on UART0 when booting a upstream kernel. > > Signed-off-by: Peter Griffin > Reviewed-by: Simon Glass Applied to u-boot/master, thanks! -- Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 836 bytes Desc: Digital signature URL: