[U-Boot] [PATCH] nios2: set default cache configuration in start.S

[Marek Vasut <marex@denx.de>]

On Friday, October 09, 2015 at 11:03:36 AM, Thomas Chou wrote:
> Hi Marek,

Hi,

> On 10/09/2015 05:14 AM, Marek Vasut wrote:
> > Did I miss the DT part somewhere or is that not part of this patch ?
> 
> As we are just barely starting from reset, there is no luxury of DT.
> After this, DT will be used with the cache flush patch.

That's right.

> > Another question I have is -- why don't we set CONFIG_SYS_{I,D}CACHE_SIZE
> > to maximum value? This should work for all nios2 cache configurations
> > and it should also be correct, no ? Speed might be a bit of an issue
> > here, but I doubt the impact would be that large.
> 
> I am doing all the best to get rid of the CONFIG_SYS_{I,D}CACHE_SIZE...
> So I avoid to use the same macro names. Here I use the maximum value in
> this startup only. The speed penalty is only once here. After we get DT
> initialized, we have the correct values of cache configuration.

Ah, right. That's good.

> It might be awful to use the maximum value all the time. See, we flush
> cache for every eth packet!

You should only flush the part where the packet is located ;-) I finally
have the MAX10 kit, so I can check the ethernet at least :)

> Thanks a lot for your review.

Thanks for keeping up with my weird questions ;-)

Best regards,
Marek Vasut