[U-Boot] [PULL] u-boot-usb/master

Simon Glass
2016-02-12T19:57:41Z

Hi,

On 11 February 2016 at 17:07, Stephen Warren <swarren@wwwdotorg.org> wrote:
> On 02/11/2016 04:59 PM, Simon Glass wrote:
>>
>> +Stephen, Ted
>>
>> Hi,
>>
>> On 25 January 2016 at 15:21, Marek Vasut <marex@denx.de> wrote:
>>>
>>> The following changes since commit
>>> 12f229ea8f6c8e20f8fd07906eafc853c4c354a9:
>>>
>>> Merge git://git.denx.de/u-boot-fdt (2016-01-22 17:01:22 -0500)
>>>
>>> are available in the git repository at:
>>>
>>> git://git.denx.de/u-boot-usb.git master
>>>
>>> for you to fetch changes up to bdbcbe752e93357226cba12a6ce00bbe54cb5db8:
>>>
>>> usb: kbd: Prevent out of bound access (2016-01-25 22:00:46 +0100)
>>>
>>> ----------------------------------------------------------------
>>> Marek Vasut (1):
>>> usb: kbd: Prevent out of bound access
>>>
>>> Masahiro Yamada (1):
>>> usb: add clock support for generic EHCI
>>>
>>> Stefan Br?ns (7):
>>> usb: dwc2: Fix out-of-bounds access, fix chunk size
>>> usb: dwc2: Simplify wait_for_chhltd(), remove ignore_ack
>>> usb: dwc2: split transfer core from outer loop
>>> usb: dwc2: add helper function for setting SPLIT HC registers
>>> usb: dwc2: Implement SPLIT transaction support
>>> usb: dwc2: Add SPLIT INTERRUPT transaction support
>>> usb: dwc2: Do not mix data toggle for IN and OUT endpoints, check
>>> bounds
>>>
>>> Stephen Warren (1):
>>> ARM: rpi: enable USB keyboard
>>>
>>> Ted Chen (1):
>>> usb: eth: add Realtek RTL8152B/RTL8153 DRIVER
>>
>>
>> This brings in a driver that does not support driver model. There was
>> one more to convert and then we would be able to move everything to
>> driver model for USB Ethernet. This makes the job harder.
>>
>> Stephen or Ted, are you able to send a patch to convert it?
>
>
> I thought the patch wasn't going to be accepted until it was converted.
> Perhaps it was applied too early?
>
> Anyway, I am not likely to be able to use the driver in the near future due
> to lack of HW to test it on, so Ted is the best candidate to port it over.

Possibly, although I'd settle for just converting it and testing it
later. It's a new driver. Also at present it's dead code as no board
includes it. Plus it should use Kconfig...

Regards,
Simon