[U-Boot] [PATCH v2 2/3] usb: s3c-otg: Fix short packet for request size > ep.maxpacket

[Lukasz Majewski <l.majewski@samsung.com>]

Hi Roger,

> Request size can be greater than ep.packet and still end in a
> short packet. We need to tackle this case as end of transfer
> (if short_not_ok is not set) as indicated in USB 2.0 Specification
> [1], else we get stuck up on certain protocols like fastboot.
> 
> [1] - USB2.0 Specification, Section 5.3.2 Pipes
> 
> Reported-by: Steve Rae <steve.rae@broadcom.com>
> Signed-off-by: Roger Quadros <rogerq@ti.com>
> Tested-by: Steve Rae <steve.rae@broadcom.com>
> ---
>  drivers/usb/gadget/dwc2_udc_otg_xfer_dma.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/drivers/usb/gadget/dwc2_udc_otg_xfer_dma.c
> b/drivers/usb/gadget/dwc2_udc_otg_xfer_dma.c index bce9c30..9aa0f33
> 100644 --- a/drivers/usb/gadget/dwc2_udc_otg_xfer_dma.c
> +++ b/drivers/usb/gadget/dwc2_udc_otg_xfer_dma.c
> @@ -229,7 +229,7 @@ static void complete_rx(struct dwc2_udc *dev, u8
> ep_num) ROUND(xfer_size, CONFIG_SYS_CACHELINE_SIZE));
>  
>  	req->req.actual += min(xfer_size, req->req.length -
> req->req.actual);
> -	is_short = (xfer_size < ep->ep.maxpacket);
> +	is_short = !!(xfer_size % ep->ep.maxpacket);
>  
>  	debug_cond(DEBUG_OUT_EP != 0,
>  		   "%s: RX DMA done : ep = %d, rx bytes = %d/%d, "

Tested-by: Lukasz Majewski <l.majewski@samsung.com>

Test HW: Odroid U3 (Exynos 4412)

Test: ./test/py DFU & UMS

-- 
Best regards,

Lukasz Majewski

Samsung R&D Institute Poland (SRPOL) | Linux Platform Group