[U-Boot] [PATCH 1/2] ARM: OMAP5+: vcores: Drop unnecessary #ifndefs

[Lokesh Vutla <lokeshvutla@ti.com>]

gpio_en field is introduced to detect if pmic is controlled by GPIO.
Make this field 0 on all TPS659* pmics available on DRA7/OMAP5 based platforms
and remove the #ifndefs.

Reviewed-by:  Keerthy <j-keerthy@ti.com>
Signed-off-by: Lokesh Vutla <lokeshvutla@ti.com>
---
 arch/arm/cpu/armv7/omap-common/clocks-common.c | 7 +------
 arch/arm/cpu/armv7/omap5/hw_data.c             | 2 ++
 2 files changed, 3 insertions(+), 6 deletions(-)

diff --git a/arch/arm/cpu/armv7/omap-common/clocks-common.c b/arch/arm/cpu/armv7/omap-common/clocks-common.c
index 2de9935..7e5e752 100644
--- a/arch/arm/cpu/armv7/omap-common/clocks-common.c
+++ b/arch/arm/cpu/armv7/omap-common/clocks-common.c
@@ -443,15 +443,12 @@ void do_scale_vcore(u32 vcore_reg, u32 volt_mv, struct pmic_data *pmic)
 {
 	u32 offset_code;
 	u32 offset = volt_mv;
-#ifndef	CONFIG_DRA7XX
 	int ret = 0;
-#endif
 
 	if (!volt_mv)
 		return;
 
 	pmic->pmic_bus_init();
-#ifndef	CONFIG_DRA7XX
 	/* See if we can first get the GPIO if needed */
 	if (pmic->gpio_en)
 		ret = gpio_request(pmic->gpio, "PMIC_GPIO");
@@ -465,7 +462,7 @@ void do_scale_vcore(u32 vcore_reg, u32 volt_mv, struct pmic_data *pmic)
 	/* Pull the GPIO low to select SET0 register, while we program SET1 */
 	if (pmic->gpio_en)
 		gpio_direction_output(pmic->gpio, 0);
-#endif
+
 	/* convert to uV for better accuracy in the calculations */
 	offset *= 1000;
 
@@ -476,10 +473,8 @@ void do_scale_vcore(u32 vcore_reg, u32 volt_mv, struct pmic_data *pmic)
 
 	if (pmic->pmic_write(pmic->i2c_slave_addr, vcore_reg, offset_code))
 		printf("Scaling voltage failed for 0x%x\n", vcore_reg);
-#ifndef	CONFIG_DRA7XX
 	if (pmic->gpio_en)
 		gpio_direction_output(pmic->gpio, 1);
-#endif
 }
 
 static u32 optimize_vcore_voltage(struct volts const *v)
diff --git a/arch/arm/cpu/armv7/omap5/hw_data.c b/arch/arm/cpu/armv7/omap5/hw_data.c
index a83f68c..fc99135 100644
--- a/arch/arm/cpu/armv7/omap5/hw_data.c
+++ b/arch/arm/cpu/armv7/omap5/hw_data.c
@@ -318,6 +318,7 @@ struct pmic_data palmas = {
 	.i2c_slave_addr	= SMPS_I2C_SLAVE_ADDR,
 	.pmic_bus_init	= sri2c_init,
 	.pmic_write	= omap_vc_bypass_send_value,
+	.gpio_en = 0,
 };
 
 /* The TPS659038 and TPS65917 are software-compatible, use common struct */
@@ -332,6 +333,7 @@ struct pmic_data tps659038 = {
 	.i2c_slave_addr	= TPS659038_I2C_SLAVE_ADDR,
 	.pmic_bus_init	= gpi2c_init,
 	.pmic_write	= palmas_i2c_write_u8,
+	.gpio_en = 0,
 };
 
 struct vcores_data omap5430_volts = {
-- 
2.9.3