public inbox for u-boot@lists.denx.de
 help / color / mirror / Atom feed
From: Yann E. MORIN <yann.morin.1998@free.fr>
To: u-boot@lists.denx.de
Subject: [U-Boot] [PATCH] arm: sunxi: do not force USB for arch-sunxi
Date: Thu, 10 Nov 2016 19:00:33 +0100	[thread overview]
Message-ID: <20161110180033.GB3564@free.fr> (raw)
In-Reply-To: <1477949620-31642-1-git-send-email-yann.morin.1998@free.fr>

Ian, Hans, All,

On 2016-10-31 22:33 +0100, Yann E. MORIN spake thusly:
> Currently, USB is forced-enabled for the sunxi familly, and there is no
> way to disable it.
> 
> However, USB takes a long time to initiliase, delaying the boot by up to
> 5 seconds (without any USB device attached!). This is a very long delay,
> especially in cases where USB booting is not wanted at all, and where
> the device is expected to boot relatively often (even in production).
> 
> Change the way the dependencies are handled, by only forcibly selecting
> USB when CONFIG_DISTRO_DEFAULTS ("defaults suitable for booting general
> purpose Linux distributions") is set. This option defaults to y for the
> sunxi familly, so the current default behaviour is kept unchanged. Users
> interested in boot time and/or size will be able to disable this to
> further disable USB.
> 
> With USB disabled, the time spent in U-Boot before handing control to
> the Linux kernel is about 1s now, down from ~5s (Nanopi Neo, sunxi H3).

Just a gentle ping... ;-)

Regards,
Yann E. MORIN.

> Signed-off-by: "Yann E. MORIN" <yann.morin.1998@free.fr>
> Cc: Ian Campbell <ijc@hellion.org.uk>
> Cc: Hans De Goede <hdegoede@redhat.com>
> 
> ---
> This is a tentative patch, acting as an RFC (unless it is good to go as
> is, of course!).
> 
> This has been discussed on IRC with <ssvb> and <apritzel>, and this
> solution is what emerged from the discussions as a first step.
> 
> The second step would be to defer intialisation of drivers until they
> are actually needed, i.e. if main boot is not from USB, then don't
> initiliase USB; if main boot fails, then initialise addtional drivers,
> like USB... Or something along those lines... That's a much tougher
> work for me, though...
> 
> There are other features that are currently forced like USB, but USB
> is by far the worst "offender" and a low-hanging fruit. Those other
> "offenders" can be handled in follow up changes.
> ---
>  arch/arm/Kconfig | 10 +++++-----
>  1 file changed, 5 insertions(+), 5 deletions(-)
> 
> diff --git a/arch/arm/Kconfig b/arch/arm/Kconfig
> index d7a9b11..c13f60f 100644
> --- a/arch/arm/Kconfig
> +++ b/arch/arm/Kconfig
> @@ -561,22 +561,22 @@ config ARCH_SUNXI
>  	bool "Support sunxi (Allwinner) SoCs"
>  	select CMD_GPIO
>  	select CMD_MMC if MMC
> -	select CMD_USB
> +	select CMD_USB if DISTRO_DEFAULTS
>  	select DM
>  	select DM_ETH
>  	select DM_GPIO
>  	select DM_KEYBOARD
>  	select DM_SERIAL
> -	select DM_USB
> +	select DM_USB if DISTRO_DEFAULTS
>  	select OF_BOARD_SETUP
>  	select OF_CONTROL
>  	select OF_SEPARATE
>  	select SPL_STACK_R if SUPPORT_SPL
>  	select SPL_SYS_MALLOC_SIMPLE if SUPPORT_SPL
>  	select SYS_NS16550
> -	select USB
> -	select USB_STORAGE
> -	select USB_KEYBOARD
> +	select USB if DISTRO_DEFAULTS
> +	select USB_STORAGE if DISTRO_DEFAULTS
> +	select USB_KEYBOARD if DISTRO_DEFAULTS
>  	select USE_TINY_PRINTF
>  
>  config TARGET_TS4800
> -- 
> 2.7.4
> 

-- 
.-----------------.--------------------.------------------.--------------------.
|  Yann E. MORIN  | Real-Time Embedded | /"\ ASCII RIBBON | Erics' conspiracy: |
| +33 662 376 056 | Software  Designer | \ / CAMPAIGN     |  ___               |
| +33 223 225 172 `------------.-------:  X  AGAINST      |  \e/  There is no  |
| http://ymorin.is-a-geek.org/ | _/*\_ | / \ HTML MAIL    |   v   conspiracy.  |
'------------------------------^-------^------------------^--------------------'

  reply	other threads:[~2016-11-10 18:00 UTC|newest]

Thread overview: 5+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2016-10-31 21:33 [U-Boot] [PATCH] arm: sunxi: do not force USB for arch-sunxi Yann E. MORIN
2016-11-10 18:00 ` Yann E. MORIN [this message]
2016-11-10 19:10   ` Hans de Goede
2016-11-10 19:36     ` Yann E. MORIN
2016-11-13 18:48 ` Hans de Goede

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20161110180033.GB3564@free.fr \
    --to=yann.morin.1998@free.fr \
    --cc=u-boot@lists.denx.de \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox