[U-Boot] [PATCH 5/8] rockchip: rk3188: Setup the armclk in spl

[Heiko Stuebner <heiko@sntech.de>]

The armclk starts in slow mode (24MHz) on the rk3188, which results in U-Boot
startup taking a lot of time (U-Boot itself, but also the rc4 decoding done
in the bootrom).

With default pmic settings we can always reach a safe frequency of 600MHz
which is also the frequency the proprietary loader left the armclk at,
without needing access to the systems pmic.

Signed-off-by: Heiko Stuebner <heiko@sntech.de>
---
 arch/arm/mach-rockchip/rk3188-board-spl.c | 24 ++++++++++++++++++++++++
 1 file changed, 24 insertions(+)

diff --git a/arch/arm/mach-rockchip/rk3188-board-spl.c b/arch/arm/mach-rockchip/rk3188-board-spl.c
index af4623fdb0..affd959f86 100644
--- a/arch/arm/mach-rockchip/rk3188-board-spl.c
+++ b/arch/arm/mach-rockchip/rk3188-board-spl.c
@@ -4,6 +4,7 @@
  * SPDX-License-Identifier:     GPL-2.0+
  */
 
+#include <clk.h>
 #include <common.h>
 #include <debug_uart.h>
 #include <dm.h>
@@ -76,6 +77,27 @@ u32 spl_boot_mode(const u32 boot_device)
 	return MMCSD_MODE_RAW;
 }
 
+static int setup_arm_clock(void)
+{
+	struct udevice *dev;
+	struct clk clk;
+	int ret;
+
+	ret = rockchip_get_clk(&dev);
+	if (ret)
+		return ret;
+
+	clk.id = CLK_ARM;
+	ret = clk_request(dev, &clk);
+	if (ret < 0)
+		return ret;
+
+	ret = clk_set_rate(&clk, 600000000);
+
+	clk_free(&clk);
+	return ret;
+}
+
 void board_init_f(ulong dummy)
 {
 	struct udevice *pinctrl, *dev;
@@ -144,6 +166,8 @@ void board_init_f(ulong dummy)
 		return;
 	}
 
+	setup_arm_clock();
+
 #if defined(CONFIG_ROCKCHIP_SPL_BACK_TO_BROM) && !defined(CONFIG_SPL_BOARD_INIT)
 	back_to_bootrom();
 #endif
-- 
2.11.0