From mboxrd@z Thu Jan 1 00:00:00 1970 From: Tom Rini Date: Tue, 11 Jul 2017 08:38:08 -0400 Subject: [U-Boot] [U-Boot, v4, 01/30] ti: common: board_detect: Allow settings board detection variables manually In-Reply-To: <20170616222533.25008-2-fcooper@ti.com> References: <20170616222533.25008-2-fcooper@ti.com> Message-ID: <20170711123808.GO22707@bill-the-cat> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Fri, Jun 16, 2017 at 05:25:04PM -0500, Cooper Jr., Franklin wrote: > From: Nishanth Menon > > In some situations the EEPROM used for board detection may not be > programmed or simply programmed incorrectly. Therefore, it may be > necessary to "simulate" reading the contents of the EEPROM to set > appropriate variables used in the board detection code. > > This may also be helpful in certain boot modes where doing i2c reads > may be costly and the config supports running only a specific board. > > Signed-off-by: Nishanth Menon > Signed-off-by: Tero Kristo > Signed-off-by: Keerthy > Signed-off-by: Franklin S Cooper Jr. > Reviewed-by: Tom Rini Applied to u-boot/master, thanks! -- Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 819 bytes Desc: Digital signature URL: