[U-Boot] [PATCH v4 11/18] mtd: nand: drv: use get_nand_dev_by_index()

Grygorii Strashko
2017-06-27T00:13:01Z

As part of preparation for nand DM conversion the new API has been
introduced to remove direct access to nand_info array. So, use it here
instead of accessing to nand_info array directly

Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com>
---
drivers/mtd/nand/fsmc_nand.c | 2 +-
drivers/mtd/nand/zynq_nand.c | 2 +-
2 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/mtd/nand/fsmc_nand.c b/drivers/mtd/nand/fsmc_nand.c
index a1f2cba..d5d1056 100644
--- a/drivers/mtd/nand/fsmc_nand.c
+++ b/drivers/mtd/nand/fsmc_nand.c
@@ -409,7 +409,7 @@ int fsmc_nand_switch_ecc(uint32_t eccstrength)
* Nomadik SoC is currently supporting this fsmc_nand_switch_ecc()
* function, as it doesn't need to switch to a different ECC layout.
*/
- mtd = nand_info[nand_curr_device];
+ mtd = get_nand_dev_by_index(nand_curr_device);
nand = mtd_to_nand(mtd);

/* Setup the ecc configurations again */
diff --git a/drivers/mtd/nand/zynq_nand.c b/drivers/mtd/nand/zynq_nand.c
index cb3340d..948f059 100644
--- a/drivers/mtd/nand/zynq_nand.c
+++ b/drivers/mtd/nand/zynq_nand.c
@@ -1008,7 +1008,7 @@ static int zynq_nand_init(struct nand_chip *nand_chip, int devnum)
}

xnand->nand_base = (void __iomem *)ZYNQ_NAND_BASEADDR;
- mtd = (struct mtd_info *)&nand_info[0];
+ mtd = get_nand_dev_by_index(0);

nand_chip->priv = xnand;
mtd->priv = nand_chip;
--
2.10.1