[U-Boot] [PATCH v2 02/11] drivers: spi: cf_spi: add Kconfig option

[Angelo Dureghello <angelo@sysam.it>]

On Wed, Oct 10, 2018 at 11:21:45AM +0530, Jagan Teki wrote:
> On Wed, Oct 10, 2018 at 11:14 AM Angelo Dureghello <angelo@sysam.it> wrote:
> >
> 
> Commit message?
>
Ok, will add it, v3 in short.
 
> > Signed-off-by: Angelo Dureghello <angelo@sysam.it>
> > ---
> > Changes for v2:
> > - new patch
> > ---
> >  drivers/spi/Kconfig | 18 ++++++++++++------
> >  1 file changed, 12 insertions(+), 6 deletions(-)
> >
> > diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig
> > index 196767a3f6..6340453870 100644
> > --- a/drivers/spi/Kconfig
> > +++ b/drivers/spi/Kconfig
> > @@ -87,6 +87,12 @@ config CADENCE_QSPI
> >           used to access the SPI NOR flash on platforms embedding this
> >           Cadence IP core.
> >
> > +config CF_SPI
> > +        bool "ColdFire SPI driver"
> > +        help
> > +          Enable the ColdFire SPI driver. This driver can be used on
> > +          some m68k SoCs.
> > +
> >  config DESIGNWARE_SPI
> >         bool "Designware SPI driver"
> >         help
> > @@ -259,18 +265,18 @@ config ZYNQMP_GQSPI
> >
> >  endif # if DM_SPI
> >
> > -config SOFT_SPI
> > -       bool "Soft SPI driver"
> > -       help
> > -        Enable Soft SPI driver. This driver is to use GPIO simulate
> > -        the SPI protocol.
> > -
> >  config CF_SPI
> >         bool "ColdFire SPI driver"
> >         help
> >           Enable the ColdFire SPI driver. This driver can be used on
> >           some m68k SoCs.
> >
> > +config SOFT_SPI
> > +       bool "Soft SPI driver"
> > +       help
> > +        Enable Soft SPI driver. This driver is to use GPIO simulate
> > +        the SPI protocol.
> > +
> 
> Why this move?

Kconfig must keep alphabetical order.