From mboxrd@z Thu Jan 1 00:00:00 1970 From: Fabio Estevam Date: Thu, 14 Feb 2019 11:35:46 -0200 Subject: [U-Boot] [PATCH v2] mx6ul_14x14_evk: Simplify the PMIC register writes Message-ID: <20190214133546.1357-1-festevam@gmail.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de There is no need to store the values written to the PMIC inside the 'reg' variable. Make it simpler by writing the values directly. Signed-off-by: Fabio Estevam --- Changes since v1: - Remove 1/2 notation, since this is a standalome patch - Add Peng Fan on Cc board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c | 9 +++------ 1 file changed, 3 insertions(+), 6 deletions(-) diff --git a/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c b/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c index 595ad76bbe..636c008993 100644 --- a/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c +++ b/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c @@ -86,16 +86,13 @@ int power_init_board(void) pmic_reg_write(dev, PFUZE3000_LDOGCTL, reg); /* SW1B step ramp up time from 2us to 4us/25mV */ - reg = 0x40; - pmic_reg_write(dev, PFUZE3000_SW1BCONF, reg); + pmic_reg_write(dev, PFUZE3000_SW1BCONF, 0x40); /* SW1B mode to APS/PFM */ - reg = 0xc; - pmic_reg_write(dev, PFUZE3000_SW1BMODE, reg); + pmic_reg_write(dev, PFUZE3000_SW1BMODE, 0xc); /* SW1B standby voltage set to 0.975V */ - reg = 0xb; - pmic_reg_write(dev, PFUZE3000_SW1BSTBY, reg); + pmic_reg_write(dev, PFUZE3000_SW1BSTBY, 0xb); return 0; } -- 2.17.1