From mboxrd@z Thu Jan 1 00:00:00 1970 From: Urja Rannikko Date: Fri, 22 Mar 2019 19:14:34 +0000 Subject: [U-Boot] [PATCH 2/4] rk3288-board: remove pinctrl call for debug uart In-Reply-To: <20190322191436.6268-1-urjaman@gmail.com> References: <20190322191436.6268-1-urjaman@gmail.com> Message-ID: <20190322191436.6268-3-urjaman@gmail.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de This failed and caused a boot failure on c201, and afaik the pins should be setup by the new pinctrl driver. Signed-off-by: Urja Rannikko --- arch/arm/mach-rockchip/rk3288-board.c | 12 ------------ 1 file changed, 12 deletions(-) diff --git a/arch/arm/mach-rockchip/rk3288-board.c b/arch/arm/mach-rockchip/rk3288-board.c index 9c4f7f219f..f5df44dab1 100644 --- a/arch/arm/mach-rockchip/rk3288-board.c +++ b/arch/arm/mach-rockchip/rk3288-board.c @@ -321,7 +321,6 @@ int board_early_init_f(void) { const uintptr_t GRF_SOC_CON0 = 0xff770244; const uintptr_t GRF_SOC_CON2 = 0xff77024c; - struct udevice *pinctrl; struct udevice *dev; int ret; @@ -335,18 +334,7 @@ int board_early_init_f(void) debug("CLK init failed: %d\n", ret); return ret; } - ret = uclass_get_device(UCLASS_PINCTRL, 0, &pinctrl); - if (ret) { - debug("%s: Cannot find pinctrl device\n", __func__); - return ret; - } - /* Enable debug UART */ - ret = pinctrl_request_noflags(pinctrl, PERIPH_ID_UART_DBG); - if (ret) { - debug("%s: Failed to set up console UART\n", __func__); - return ret; - } rk_setreg(GRF_SOC_CON2, 1 << 0); /* -- 2.21.0