[U-Boot] [PATCH v2 1/2] wandboard: Don't use I2C speed Kconfig settings with DM_I2C

[Anatolij Gustschin <agust@denx.de>]

On Wed, 8 May 2019 23:30:01 +0000
Trent Piepho tpiepho at impinj.com wrote:
...
> diff --git a/board/wandboard/wandboard.c b/board/wandboard/wandboard.c
> index 69fbc8b690..9d7a94ff9d 100644
> --- a/board/wandboard/wandboard.c
> +++ b/board/wandboard/wandboard.c
> @@ -46,6 +46,15 @@ DECLARE_GLOBAL_DATA_PTR;
>  #define ETH_PHY_AR8035_POWER	IMX_GPIO_NR(7, 13)
>  #define REV_DETECTION		IMX_GPIO_NR(2, 28)
>  
> +/* Speed defined in Kconfig is only applicable when not using DM_I2C.  */
> +#ifdef CONFIG_DM_I2C
> +#define I2C1_SPEED_NON_DM	0
> +#define I2C2_SPEED_NON_DM	0
> +#else
> +#define I2C1_SPEED_NON_DM	CONFIG_SYS_MXC_I2C1_SPEED
> +#define I2C2_SPEED_NON_DM	CONFIG_SYS_MXC_I2C2_SPEED

Shouldn't we change this to

#ifdef CONFIG_DM_I2C
#define I2C2_SPEED_NON_DM	0
#define I2C3_SPEED_NON_DM	0
#else
#define I2C2_SPEED_NON_DM	CONFIG_SYS_MXC_I2C2_SPEED
#define I2C3_SPEED_NON_DM	CONFIG_SYS_MXC_I2C3_SPEED
#endif
...
setup_i2c(1, I2C2_SPEED_NON_DM, 0x7f, &mx6q_i2c2_pad_info);
setup_i2c(2, I2C3_SPEED_NON_DM, 0x7f, &mx6q_i2c3_pad_info);
?

Because the first argument to setup_i2c() is the bus number
which starts counting from 0, but the CONFIG_SYS_MXC_I2C*
start counting from 1. This doesn't affect the actual
configuration since the speed value is currently the same
for all buses. But it is more accurate.

--
Anatolij