From mboxrd@z Thu Jan  1 00:00:00 1970
From: Adam Ford <aford173@gmail.com>
Date: Thu, 23 May 2019 14:11:32 -0500
Subject: [U-Boot] [PATCH 3/3] ARM: imx6q_logic: With SPL_OF_CONTROL enabled,
	remove MMC init
In-Reply-To: <20190523191132.17439-1-aford173@gmail.com>
References: <20190523191132.17439-1-aford173@gmail.com>
Message-ID: <20190523191132.17439-3-aford173@gmail.com>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

Since the board uses SPL_OF_CONTROL now, we don't need to
explicitly initialize the MMC driver, but we still need to
pinmux the corresponding pins.  This patch removes the
initialization code and leave just the muxing behind.

Signed-off-by: Adam Ford <aford173@gmail.com>

diff --git a/board/logicpd/imx6/imx6logic.c b/board/logicpd/imx6/imx6logic.c
index b17a3b1d39..ab1c7f266e 100644
--- a/board/logicpd/imx6/imx6logic.c
+++ b/board/logicpd/imx6/imx6logic.c
@@ -222,25 +222,15 @@ int board_mmc_init(bd_t *bis)
 	switch (reg) {
 	case 0:
 		SETUP_IOMUX_PADS(usdhc1_pads);
-		usdhc_cfg[0].esdhc_base = USDHC1_BASE_ADDR;
-		usdhc_cfg[0].sdhc_clk = mxc_get_clock(MXC_ESDHC_CLK);
-		gd->arch.sdhc_clk = usdhc_cfg[0].sdhc_clk;
 		break;
 	case 1:
 		SETUP_IOMUX_PADS(usdhc2_pads);
-		usdhc_cfg[1].esdhc_base = USDHC2_BASE_ADDR;
-		usdhc_cfg[1].sdhc_clk = mxc_get_clock(MXC_ESDHC2_CLK);
-		gd->arch.sdhc_clk = usdhc_cfg[1].sdhc_clk;
 		break;
 	}
 
-	return fsl_esdhc_initialize(bis, &usdhc_cfg[reg]);
+	return 0;
 }
 
-int board_mmc_getcd(struct mmc *mmc)
-{
-	return 1;
-}
 #endif
 
 static void ccgr_init(void)
-- 
2.17.1