From mboxrd@z Thu Jan 1 00:00:00 1970 From: Angelo Dureghello Date: Mon, 24 Jun 2019 11:26:26 +0200 Subject: [U-Boot] [v3, 5/5] mmc: fsl_esdhc_imx: drop useless code In-Reply-To: References: <20190521085215.6263-1-yangbo.lu@nxp.com> <20190521085215.6263-6-yangbo.lu@nxp.com> <20190530182325.GA4140@jerusalem> <20190531071509.GA3241@jerusalem> <20190622214238.GA11447@jerusalem> Message-ID: <20190624092626.GA6540@jerusalem> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hi Lu, -snip- > > > > > > > > Sorry for the late testing. > > > > Tested, it works on ColdFire mcf54415. But please add if possible the _IMX > > (CONFIG_FSL_ESDHC_IMX) for the sysam/stmark2 board too. > > [Y.b. Lu] Thanks a lot for your testing. > In default, CONFIG_FSL_ESDHC wasn't enabled. We can send another patch to enable CONFIG_FSL_ESDHC_IMX for ColdFire mcf54415 after this patch-set was applied. > Sorry, realized CONFIG_FSL_ESDHC was enabled only here locally. Don't worry about, sent a patch for it, in case i'll refix it later on to CONFIG_FSL_ESDHC_IMX. > > > > > > Tested-by: Angelo Dureghello > > > > > > > > Regards, > > > > Angelo Dureghello > > > > Thanks, > > Regards > > Angelo Dureghello Thanks, Regards, Angelo Dureghello