[U-Boot] [PATCH] Revert "ARM: davinci: da850: Manual pinmux only when PINCTRL not available"

[Adam Ford <aford173@gmail.com>]

This reverts commit 877ab2423bc257045a06bc23d4b9440b82bda6fb.

The above patch was designed to shrink code by only pin-muxing items
needed for SPL in SPL and relying on driver model or SPL to mux other
items.  Unfortunately, da850evm_direct_nor doesn't use SPL so items
that were only muxed during SPL are not muxed causing the board
to no longer boot.

Signed-off-by: Adam Ford <aford173@gmail.com>

diff --git a/board/davinci/da8xxevm/da850evm.c b/board/davinci/da8xxevm/da850evm.c
index fcf9334ba9..849905cf8a 100644
--- a/board/davinci/da8xxevm/da850evm.c
+++ b/board/davinci/da8xxevm/da850evm.c
@@ -215,29 +215,21 @@ static const struct pinmux_config gpio_pins[] = {
 };
 
 const struct pinmux_resource pinmuxes[] = {
-#ifndef CONFIG_SPL_BUILD
 #ifdef CONFIG_DRIVER_TI_EMAC
 	PINMUX_ITEM(emac_pins_mdio),
 #ifdef CONFIG_DRIVER_TI_EMAC_USE_RMII
 	PINMUX_ITEM(emac_pins_rmii),
 #else
 	PINMUX_ITEM(emac_pins_mii),
-#endif /* CONFIG_DRIVER_TI_EMAC */
-#endif /* CONFIG_DRIVER_TI_EMAC_USE_RMII */
-#endif /* CONFIG_SPL_BUILD */
+#endif
+#endif
 #ifdef CONFIG_SPI_FLASH
-#if !CONFIG_IS_ENABLED(PINCTRL)
 	PINMUX_ITEM(spi1_pins_base),
 	PINMUX_ITEM(spi1_pins_scs0),
 #endif
-#endif
-#if !CONFIG_IS_ENABLED(PINCTRL)
 	PINMUX_ITEM(uart2_pins_txrx),
 	PINMUX_ITEM(uart2_pins_rtscts),
-#endif
-#if !CONFIG_IS_ENABLED(PINCTRL)
 	PINMUX_ITEM(i2c0_pins),
-#endif
 #ifdef CONFIG_NAND_DAVINCI
 	PINMUX_ITEM(emifa_pins_cs3),
 	PINMUX_ITEM(emifa_pins_cs4),
@@ -248,10 +240,8 @@ const struct pinmux_resource pinmuxes[] = {
 #endif
 	PINMUX_ITEM(gpio_pins),
 #ifdef CONFIG_MMC_DAVINCI
-#if !CONFIG_IS_ENABLED(PINCTRL)
 	PINMUX_ITEM(mmc0_pins),
 #endif
-#endif
 };
 
 const int pinmuxes_size = ARRAY_SIZE(pinmuxes);
-- 
2.17.1