[U-Boot] [PATCH] spi: Kconfig: Add help text

[U-Boot] [PATCH] spi: Kconfig: Add help text

[Jagan Teki]

Add detailed help text for SPI support.

Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>
---
 drivers/spi/Kconfig | 17 +++++++++++++++++
 1 file changed, 17 insertions(+)

diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig
index b8ca2bdedd..0152dff74f 100644
--- a/drivers/spi/Kconfig
+++ b/drivers/spi/Kconfig
@@ -1,5 +1,22 @@
 menuconfig SPI
 	bool "SPI Support"
+	help
+	  The "Serial Peripheral Interface" is a low level synchronous
+          protocol.  Chips that support SPI can have data transfer rates
+          up to several tens of Mbit/sec.  Chips are addressed with a
+          controller and a chipselect.  Most SPI slaves don't support
+          dynamic device discovery; some are even write-only or read-only.
+
+          SPI is widely used by microcontrollers to talk with sensors,
+          eeprom and flash memory, codecs and various other controller
+          chips, analog to digital (and d-to-a) converters, and more.
+          MMC and SD cards can be accessed using SPI protocol; and for
+          DataFlash cards used in MMC sockets, SPI must always be used.
+
+          SPI is one of a family of similar protocols using a four wire
+          interface (select, clock, data in, data out) including Microwire
+          (half duplex), SSP, SSI, and PSP.  This driver framework should
+          work with most such devices and controllers.
 
 if SPI
 
-- 
2.18.0.321.gffc6fa0e3