From mboxrd@z Thu Jan  1 00:00:00 1970
From: Jorge Ramirez-Ortiz, Gmail <jorge.ramirez.ortiz@gmail.com>
Date: Fri, 17 Jan 2020 19:40:16 +0100
Subject: question: mx7ulp - LDO_ENABLED_MODE
In-Reply-To: <CAOMZO5CgMpGJsCGdgKi1CCFP4oOaF6XHW0=+cWn5qaB5uU-NoA@mail.gmail.com>
References: <20200116203000.GA21781@trex>
 <CAOMZO5BREwtHueLTzgZ=rsr+odxBVZDtfYf-F_KYi+HqK3pDjg@mail.gmail.com>
 <20200117165104.GC3054@trex>
 <CAOMZO5CgMpGJsCGdgKi1CCFP4oOaF6XHW0=+cWn5qaB5uU-NoA@mail.gmail.com>
Message-ID: <20200117184016.GD3054@trex>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="windows-1252"
Content-Transfer-Encoding: quoted-printable
To: u-boot@lists.denx.de

On 17/01/20 14:18:55, Fabio Estevam wrote:
> On Fri, Jan 17, 2020 at 1:51 PM Jorge Ramirez-Ortiz, Gmail
> <jorge.ramirez.ortiz@gmail.com> wrote:
>=20
> > btw was checking the TRM manual (Chapter 28, PMC - page 1172)
> >
> > [..]
> > PMC1 power mode[LDOVL] fields don=E2=80=99t necessarily satisfy the ope=
ration voltage levels
> > required by the system. Such operation voltage requirements can be foun=
d on i.MX 7ULP
> > Data Sheet. In this sense, no power transition should be performed befo=
re ensuring the
> > mentioned register fields are matching the required operation voltage l=
evels expressed on
> > the data sheet.
> >
> > =3D>  0.95V in the ldt_init function, is it in the data sheet?
> > I just cant find that particular document
>=20
> Yes, please take a look at https://www.nxp.com/docs/en/data-sheet/IMX7ULP=
CEC.pdf
>=20
> (Table 5 - Search for PMC1_STOP[LDOVL] where it shows 0.95V as the
> typical value)

thanks a lot Favio. The part I am working with is 08SC. (not 05 or 07).
Is that the same as yours?

wondering if something is different for this part...