From: Vignesh Raghavendra <vigneshr@ti.com>
To: u-boot@lists.denx.de
Subject: [PATCH v2 08/12] configs: j721e_evm_defconfig: Enable OSPI configs
Date: Tue, 4 Feb 2020 11:09:55 +0530 [thread overview]
Message-ID: <20200204053959.8802-9-vigneshr@ti.com> (raw)
In-Reply-To: <20200204053959.8802-1-vigneshr@ti.com>
Enable OSPI related defconfigs. Also enable SPL_DMA so that DMA is used
during OSPI boot
Signed-off-by: Vignesh Raghavendra <vigneshr@ti.com>
---
configs/j721e_evm_a72_defconfig | 9 ++++++++-
configs/j721e_evm_r5_defconfig | 7 +++++++
2 files changed, 15 insertions(+), 1 deletion(-)
diff --git a/configs/j721e_evm_a72_defconfig b/configs/j721e_evm_a72_defconfig
index 8355abbaa7f2..581a4c45402b 100644
--- a/configs/j721e_evm_a72_defconfig
+++ b/configs/j721e_evm_a72_defconfig
@@ -27,6 +27,7 @@ CONFIG_SPL_BOARD_INIT=y
CONFIG_SPL_SYS_MALLOC_SIMPLE=y
CONFIG_SPL_STACK_R=y
CONFIG_SPL_SEPARATE_BSS=y
+CONFIG_SPL_DMA=y
CONFIG_SPL_ENV_SUPPORT=y
CONFIG_SPL_I2C_SUPPORT=y
CONFIG_SPL_DM_MAILBOX=y
@@ -35,6 +36,8 @@ CONFIG_SPL_POWER_SUPPORT=y
CONFIG_SPL_POWER_DOMAIN=y
CONFIG_SPL_RAM_SUPPORT=y
CONFIG_SPL_RAM_DEVICE=y
+# CONFIG_SPL_SPI_FLASH_TINY is not set
+CONFIG_SPL_SPI_FLASH_SFDP_SUPPORT=y
CONFIG_SPL_SPI_LOAD=y
CONFIG_SYS_SPI_U_BOOT_OFFS=0x280000
CONFIG_SPL_USB_GADGET=y
@@ -56,7 +59,8 @@ CONFIG_CMD_USB_MASS_STORAGE=y
CONFIG_CMD_TIME=y
CONFIG_CMD_EXT4_WRITE=y
CONFIG_MTDIDS_DEFAULT="nor0=47040000.spi.0,nor0=47034000.hyperbus"
-CONFIG_MTDPARTS_DEFAULT="mtdparts=47034000.hyperbus:512k(hbmc.tiboot3),2m(hbmc.tispl),4m(hbmc.u-boot),256k(hbmc.env),1m(hbmc.sysfw),- at 8m(hbmc.rootfs)"
+CONFIG_MTDPARTS_DEFAULT="mtdparts=47040000.spi.0:512k(ospi.tiboot3),2m(ospi.tispl),4m(ospi.u-boot),128k(ospi.env),128k(ospi.env.backup),1m(ospi.sysfw),- at 8m(ospi.rootfs);47034000.hyperbus:512k(hbmc.tiboot3),2m(hbmc.tispl),4m(hbmc.u-boot),256k(hbmc.env),1m(hbmc.sysfw),- at 8m(hbmc.rootfs)"
+CONFIG_CMD_UBI=y
# CONFIG_ISO_PARTITION is not set
# CONFIG_SPL_EFI_PARTITION is not set
CONFIG_OF_CONTROL=y
@@ -113,7 +117,10 @@ CONFIG_FLASH_CFI_MTD=y
CONFIG_SYS_FLASH_CFI=y
CONFIG_HBMC_AM654=y
CONFIG_DM_SPI_FLASH=y
+CONFIG_SPI_FLASH_SFDP_SUPPORT
CONFIG_SPI_FLASH_STMICRO=y
+# CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
+CONFIG_SPI_FLASH_MTD=y
CONFIG_PHY_TI=y
CONFIG_PHY_FIXED=y
CONFIG_DM_ETH=y
diff --git a/configs/j721e_evm_r5_defconfig b/configs/j721e_evm_r5_defconfig
index 19fbd450c754..d31c116aa695 100644
--- a/configs/j721e_evm_r5_defconfig
+++ b/configs/j721e_evm_r5_defconfig
@@ -25,6 +25,7 @@ CONFIG_USE_BOOTCOMMAND=y
CONFIG_SPL_STACK_R=y
CONFIG_SPL_SEPARATE_BSS=y
CONFIG_SPL_EARLY_BSS=y
+CONFIG_SPL_DMA=y
CONFIG_SPL_ENV_SUPPORT=y
CONFIG_SPL_I2C_SUPPORT=y
CONFIG_SPL_DM_MAILBOX=y
@@ -34,6 +35,8 @@ CONFIG_SPL_POWER_DOMAIN=y
CONFIG_SPL_RAM_SUPPORT=y
CONFIG_SPL_RAM_DEVICE=y
CONFIG_SPL_REMOTEPROC=y
+# CONFIG_SPL_SPI_FLASH_TINY is not set
+CONFIG_SPL_SPI_FLASH_SFDP_SUPPORT=y
CONFIG_SPL_SPI_LOAD=y
CONFIG_SYS_SPI_U_BOOT_OFFS=0x80000
CONFIG_SPL_USB_GADGET=y
@@ -64,6 +67,8 @@ CONFIG_SPL_OF_TRANSLATE=y
CONFIG_CLK=y
CONFIG_SPL_CLK=y
CONFIG_CLK_TI_SCI=y
+CONFIG_DMA_CHANNELS=y
+CONFIG_TI_K3_NAVSS_UDMA=y
CONFIG_TI_SCI_PROTOCOL=y
CONFIG_DA8XX_GPIO=y
CONFIG_DM_PCA953X=y
@@ -81,6 +86,7 @@ CONFIG_SPL_MMC_SDHCI_ADMA=y
CONFIG_MMC_SDHCI_AM654=y
CONFIG_MTD=y
CONFIG_DM_SPI_FLASH=y
+CONFIG_SPI_FLASH_SFDP_SUPPORT=y
CONFIG_SPI_FLASH_STMICRO=y
CONFIG_PINCTRL=y
# CONFIG_PINCTRL_GENERIC is not set
@@ -99,6 +105,7 @@ CONFIG_REMOTEPROC_TI_K3_ARM64=y
CONFIG_DM_RESET=y
CONFIG_RESET_TI_SCI=y
CONFIG_DM_SERIAL=y
+CONFIG_SOC_TI=y
CONFIG_SPI=y
CONFIG_DM_SPI=y
CONFIG_CADENCE_QSPI=y
--
2.25.0
next prev parent reply other threads:[~2020-02-04 5:39 UTC|newest]
Thread overview: 16+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-02-04 5:39 [PATCH v2 00/12] TI: AM654/J721e: Add support to boot from OSPI Vignesh Raghavendra
2020-02-04 5:39 ` [PATCH v2 01/12] drivers: Descend to drivers/soc unconditionally Vignesh Raghavendra
2020-06-02 13:46 ` Simon Glass
2020-02-04 5:39 ` [PATCH v2 02/12] ARM: mach-k3: arm64-mmu: map 64bit FSS MMIO space in A53 MMU Vignesh Raghavendra
2020-02-04 5:39 ` [PATCH v2 03/12] ARM: mach-k3: sysfw-loader: Use SPI memmapped addr when loading SYSFW Vignesh Raghavendra
2020-02-04 5:39 ` [PATCH v2 04/12] ARM: dts: k3-am65: Add OSPI DT nodes Vignesh Raghavendra
2020-02-04 5:39 ` [PATCH v2 05/12] ARM: dts: k3-j721e: " Vignesh Raghavendra
2020-02-04 5:39 ` [PATCH v2 06/12] configs: am65x_evm: Setup mtdparts for OSPI Vignesh Raghavendra
2020-02-04 5:39 ` [PATCH v2 07/12] configs: j721e_evm: " Vignesh Raghavendra
2020-02-04 5:39 ` Vignesh Raghavendra [this message]
2020-02-04 5:39 ` [PATCH v2 09/12] configs: am65x_evm_defconfig: Enable OSPI configs Vignesh Raghavendra
2020-02-04 5:39 ` [PATCH v2 10/12] board: ti: Update AM65x and J721e READMEs for OSPI boot Vignesh Raghavendra
2020-02-04 5:39 ` [PATCH v2 11/12] configs: ama65x_hs_evm: Enable OSPI related configs Vignesh Raghavendra
2020-02-04 5:39 ` [PATCH v2 12/12] configs: j721e_hs_evm: " Vignesh Raghavendra
2020-02-04 13:36 ` [PATCH v2 00/12] TI: AM654/J721e: Add support to boot from OSPI Andreas Dannenberg
2020-02-23 8:13 ` Lokesh Vutla
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20200204053959.8802-9-vigneshr@ti.com \
--to=vigneshr@ti.com \
--cc=u-boot@lists.denx.de \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox