From: Wolfgang Denk <wd@denx.de>
To: u-boot@lists.denx.de
Subject: [PATCH 04/16] arm: stm32mp: detect U-Boot version used to save environment
Date: Wed, 01 Apr 2020 13:26:15 +0200 [thread overview]
Message-ID: <20200401112615.931A024003E@gemini.denx.de> (raw)
In-Reply-To: <20200331160456.26254-1-patrick.delaunay@st.com>
Dear Patrick Delaunay,
In message <20200331160456.26254-1-patrick.delaunay@st.com> you wrote:
> Imply CONFIG_VERSION_VARIABLE for stm32mp1 target
> and test U-Boot version ($env_ver) when the environment was
> saved for the last time and to display warning trace.
What is env_ver? Are you by chance reinventing the wheel?
The U-Boot version is stored in the environment variable "ver";
there should be no need for something similar.
Also. where is $env_ver coming from? It does not exist in mainline,
nor in any of the 3 patches that preceed this patch # 4/16 ?
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Computers are not intelligent. They only think they are.
next prev parent reply other threads:[~2020-04-01 11:26 UTC|newest]
Thread overview: 51+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-03-31 16:04 [PATCH 01/16] arm: stm32mp: update dependency for STM32_ETZPC Patrick Delaunay
2020-03-31 16:04 ` [PATCH 02/16] arm: stm32mp: remove dependency for STM32KEY Patrick Delaunay
2020-04-01 7:19 ` Patrice CHOTARD
2020-03-31 16:04 ` [PATCH 03/16] arm: stm32mp: reset to default environment when serial# change Patrick Delaunay
2020-04-01 7:22 ` Patrice CHOTARD
2020-04-01 11:18 ` Wolfgang Denk
2020-04-07 14:31 ` Patrick DELAUNAY
2020-04-07 16:22 ` Wolfgang Denk
2020-03-31 16:04 ` [PATCH 04/16] arm: stm32mp: detect U-Boot version used to save environment Patrick Delaunay
2020-04-01 7:33 ` Patrice CHOTARD
2020-04-07 14:37 ` Patrick DELAUNAY
2020-04-01 11:26 ` Wolfgang Denk [this message]
2020-04-07 14:54 ` Patrick DELAUNAY
2020-04-07 16:28 ` Wolfgang Denk
2020-04-08 9:38 ` [Uboot-stm32] " Patrick DELAUNAY
2020-03-31 16:04 ` [PATCH 05/16] arm: stm32mp: spl: add bsec driver in SPL Patrick Delaunay
2020-04-01 7:34 ` Patrice CHOTARD
2020-04-01 11:27 ` Wolfgang Denk
2020-04-08 14:31 ` Patrick DELAUNAY
2020-03-31 16:04 ` [PATCH 06/16] arm: stm32mp: spl: display error in board_init_f Patrick Delaunay
2020-04-01 7:43 ` Patrice CHOTARD
2020-04-01 11:30 ` Wolfgang Denk
2020-04-21 16:05 ` Patrick DELAUNAY
2020-04-23 20:39 ` Wolfgang Denk
2020-04-24 8:28 ` Patrick DELAUNAY
2020-03-31 16:04 ` [PATCH 07/16] board: stm32mp1: Keep error led ON in case of low power detection Patrick Delaunay
2020-04-01 7:44 ` Patrice CHOTARD
2020-03-31 16:04 ` [PATCH 08/16] board: stm32mp1: update management of boot-led Patrick Delaunay
2020-04-01 7:49 ` [Uboot-stm32] " Patrice CHOTARD
2020-04-01 11:32 ` Wolfgang Denk
2020-04-01 11:43 ` Anatolij Gustschin
2020-04-10 17:08 ` Patrick DELAUNAY
2020-03-31 16:04 ` [PATCH 09/16] board: stm32mp1: gt9147 IRQ before reset on EV1 Patrick Delaunay
2020-04-01 7:53 ` [Uboot-stm32] " Patrice CHOTARD
2020-04-01 11:34 ` Wolfgang Denk
2020-03-31 16:04 ` [PATCH 10/16] board: stm32mp1: set environment variable fdtfile Patrick Delaunay
2020-04-01 8:06 ` [Uboot-stm32] " Patrice CHOTARD
2020-03-31 16:04 ` [PATCH 11/16] board: stm32mp1: check env_get result in board_late_init Patrick Delaunay
2020-04-01 8:06 ` [Uboot-stm32] " Patrice CHOTARD
2020-04-01 11:39 ` Wolfgang Denk
2020-03-31 16:04 ` [PATCH 12/16] board: stm32mp1: add timeout for I/O compensation ready Patrick Delaunay
2020-04-01 8:07 ` [Uboot-stm32] " Patrice CHOTARD
2020-03-31 16:04 ` [PATCH 13/16] gpio: stm32: support gpio ops in SPL Patrick Delaunay
2020-04-01 8:11 ` Patrice CHOTARD
2020-03-31 16:04 ` [PATCH 14/16] ARM: dts: stm32mp15: use DDR3 files generated by STM32CubeMX Patrick Delaunay
2020-04-01 8:08 ` [Uboot-stm32] " Patrice CHOTARD
2020-03-31 16:04 ` [PATCH 15/16] configs: stm32mp1: activate Ethernet PHY Realtek Patrick Delaunay
2020-04-01 8:08 ` [Uboot-stm32] " Patrice CHOTARD
2020-03-31 16:04 ` [PATCH 16/16] configs: stm32mp1: activate CONFIG_ERRNO_STR Patrick Delaunay
2020-04-01 8:09 ` [Uboot-stm32] " Patrice CHOTARD
2020-04-01 7:10 ` [PATCH 01/16] arm: stm32mp: update dependency for STM32_ETZPC Patrice CHOTARD
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20200401112615.931A024003E@gemini.denx.de \
--to=wd@denx.de \
--cc=u-boot@lists.denx.de \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox