[PATCH] tbs2910: migrate to DM_VIDEO

[Anatolij Gustschin <agust@denx.de>]

On Sun, 24 May 2020 17:46:22 +0200
Soeren Moch smoch at web.de wrote:

> On 23.05.20 01:24, Anatolij Gustschin wrote:
> > Migration to DM_VIDEO driver is long overdue, configure it in
> > board config files. To enable the display set stdout like:
> >
> >   setenv stdout serial,vidconsole
> >
> > Signed-off-by: Anatolij Gustschin <agust@denx.de>
> > ---
> > This is only build tested.  
> I tested this on top of v2020.07-rc2 and your patch
> "video: extend stdout video console work-around for 'vga'"
> 
> Works great. However, some comments below.

Thanks for testing!

...
> > +CONFIG_SYS_MALLOC_F_LEN=0x4000  
> This is not necessary. The default 0x2000 also works fine.

Dropped in v2.

...
> Since DM_VIDEO requires vidconsole as output device, please also add
> 
> ---8<---
> diff --git a/include/configs/tbs2910.h b/include/configs/tbs2910.h
> index 8ab3fcfe3e..82165a9ffe 100644
> --- a/include/configs/tbs2910.h
> +++ b/include/configs/tbs2910.h
> @@ -92,11 +92,11 @@
> ??????? "fan=gpio set 92\0" \
> ??????? "set_con_serial=setenv stdout serial; " \
> ??????????????????????? "setenv stderr serial\0" \
> -?????? "set_con_hdmi=setenv stdout serial,vga; " \
> -?????????????????????? "setenv stderr serial,vga\0" \
> -?????? "stderr=serial,vga\0" \
> +?????? "set_con_hdmi=setenv stdout serial,vidconsole; " \
> +?????????????????????? "setenv stderr serial,vidconsole\0" \
> +?????? "stderr=serial,vidconsole\0" \
> ??????? "stdin=serial,usbkbd\0" \
> -?????? "stdout=serial,vga\0"
> +?????? "stdout=serial,vidconsole\0"
> ?
> ?#define CONFIG_BOOTCOMMAND \
> ??????? "mmc rescan; " \
> ---8<---
> 
> to avoid warnings for users with default environment.(not sure if
> whitespace is still correct in this snippet)

Done in v2.

> With this DM_VIDEO conversion the board comes very close to the size
> limit. While it works with my toolchain, there might be problems with
> others. So maybe not a good idea to merge this as fix immediately.

Yes, with GCC 9.2 it didn't work any more. I've submitted some DM_VIDEO
patches to disable more unused code to fix this.
 
> Since this depends on your above mentioned patch, do you plan to merge
> this via u-boot-video, or should this go as usual through the imx tree?

I'll merge this via u-boot-video tree. v2 patch depends on a few more
video patches which are under review/built-test currently.

--
Anatolij