From: Eugen Hristev <eugen.hristev@microchip.com>
To: u-boot@lists.denx.de
Subject: [PATCH 00/34] Sama7g5 Evaluation Kit support
Date: Thu, 3 Dec 2020 11:28:16 +0200 [thread overview]
Message-ID: <20201203092850.7909-1-eugen.hristev@microchip.com> (raw)
Hello,
This series adds support for sama7g5 SoC DT and the sama7g5ek board.
I kept the original incremental development for this board, with each
commit's author and designated change, for traceability and for easier
reviewing.
The series starts from a basic devicetree and ends with a fully functional
board including SD-Card/MMC, i2c eeproms, ethernet.
Thanks,
Eugen
Claudiu Beznea (20):
board: atmel: sama7g5ek: add SYS_MALLOC_F_LEN to SYS_INIT_SP_ADDR
configs: sama7g5ek: set malloc pool to 68K
configs: sama7g5ek: enable pll driver
ARM: dts: sama7g5: move clock frequencies for xtals in board file
ARM: dts: sama7g5: add slow rc and main rc oscillators
ARM: dts: sama7g5: add u-boot,dm-pre-reloc bindings for xtals
ARM: dts: sama7g5: add slow clock bindings
ARM: dts: sama7g5: add PMC bindings
ARM: dts: sama7g5: switch to PMC bindings
configs: sama7g5: enable CONFIG_CPU
ARM: dts: sama7g5: add CPU bindings
configs: sama7g5: use PIT64B
ARM: dts: sama7g5: enable autoboot
ARM: dts: sama7g5: add pit64b support
configs: sama7g5ek: enable mii command
ARM: dts: sama7g5: add GMAC0
ARM: dts: sama7g5: add GMAC1
board: atmel: sama7g5ek: increase arp timeout and retry count
configs: sama7g5ek: enable support for KSZ9131
configs: sama7g5ek: enable CCF
Eugen Hristev (13):
ARM: dts: sama7g5: add initial DT for sama7g5 SoC
board: atmel: sama7g5ek: add initial support for sama7g5ek
ARM: dts: at91: sama7g5: add pinctrl node
ARM: dts: at91: sama7g5ek: add pinctrl for sdmmc1 and flx3
ARM: dts: at91: sama7g5: add assigned clocks for sdmmc1
ARM: dts: at91: sama7g5: add node for sdmmc0
ARM: dts: at91: sama7g5ek: enable sdmmc0 with pinctrl
board: atmel: sama7g5ek: clean-up header bootcommand
configs: sama7g5: add mmc config for sdmmc0
ARM: dts: at91: sama7g5: add flexcom1 and i2c subnode
ARM: dts: sama7g5ek: add i2c1 bus and eeproms
board: atmel: sama7g5ek: add support for MAC address retreival
configs: sama7g5ek: add i2c and eeprom
Nicolas Ferre (1):
ARM: dts: sama7g5ek: fix TXC pin configuration
arch/arm/dts/Makefile | 3 +
arch/arm/dts/sama7g5.dtsi | 169 ++++++++++++++++++++++++
arch/arm/dts/sama7g5ek-u-boot.dtsi | 65 ++++++++++
arch/arm/dts/sama7g5ek.dts | 202 +++++++++++++++++++++++++++++
arch/arm/mach-at91/Kconfig | 8 ++
board/atmel/sama7g5ek/Kconfig | 15 +++
board/atmel/sama7g5ek/MAINTAINERS | 8 ++
board/atmel/sama7g5ek/Makefile | 7 +
board/atmel/sama7g5ek/sama7g5ek.c | 76 +++++++++++
configs/sama7g5ek_mmc1_defconfig | 70 ++++++++++
configs/sama7g5ek_mmc_defconfig | 70 ++++++++++
include/configs/sama7g5ek.h | 45 +++++++
12 files changed, 738 insertions(+)
create mode 100644 arch/arm/dts/sama7g5.dtsi
create mode 100644 arch/arm/dts/sama7g5ek-u-boot.dtsi
create mode 100644 arch/arm/dts/sama7g5ek.dts
create mode 100644 board/atmel/sama7g5ek/Kconfig
create mode 100644 board/atmel/sama7g5ek/MAINTAINERS
create mode 100644 board/atmel/sama7g5ek/Makefile
create mode 100644 board/atmel/sama7g5ek/sama7g5ek.c
create mode 100644 configs/sama7g5ek_mmc1_defconfig
create mode 100644 configs/sama7g5ek_mmc_defconfig
create mode 100644 include/configs/sama7g5ek.h
--
2.25.1
next reply other threads:[~2020-12-03 9:28 UTC|newest]
Thread overview: 42+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-12-03 9:28 Eugen Hristev [this message]
2020-12-03 9:28 ` [PATCH 01/34] ARM: dts: sama7g5: add initial DT for sama7g5 SoC Eugen Hristev
2020-12-03 9:28 ` [PATCH 02/34] board: atmel: sama7g5ek: add initial support for sama7g5ek Eugen Hristev
2020-12-03 9:28 ` [PATCH 03/34] board: atmel: sama7g5ek: add SYS_MALLOC_F_LEN to SYS_INIT_SP_ADDR Eugen Hristev
2020-12-03 9:28 ` [PATCH 04/34] configs: sama7g5ek: set malloc pool to 68K Eugen Hristev
2020-12-03 9:28 ` [PATCH 05/34] configs: sama7g5ek: enable pll driver Eugen Hristev
2020-12-03 9:28 ` [PATCH 06/34] ARM: dts: sama7g5: move clock frequencies for xtals in board file Eugen Hristev
2020-12-03 9:28 ` [PATCH 07/34] ARM: dts: sama7g5: add slow rc and main rc oscillators Eugen Hristev
2020-12-03 9:28 ` [PATCH 08/34] ARM: dts: sama7g5: add u-boot, dm-pre-reloc bindings for xtals Eugen Hristev
2020-12-03 9:28 ` [PATCH 09/34] ARM: dts: sama7g5: add slow clock bindings Eugen Hristev
2020-12-03 9:28 ` [PATCH 10/34] ARM: dts: sama7g5: add PMC bindings Eugen Hristev
2020-12-03 9:28 ` [PATCH 11/34] ARM: dts: sama7g5: switch to " Eugen Hristev
2020-12-03 9:28 ` [PATCH 12/34] configs: sama7g5: enable CONFIG_CPU Eugen Hristev
2020-12-03 9:28 ` [PATCH 13/34] ARM: dts: sama7g5: add CPU bindings Eugen Hristev
2020-12-03 9:28 ` [PATCH 14/34] configs: sama7g5: use PIT64B Eugen Hristev
2020-12-03 9:28 ` [PATCH 15/34] ARM: dts: sama7g5: enable autoboot Eugen Hristev
2020-12-03 9:28 ` [PATCH 16/34] ARM: dts: sama7g5: add pit64b support Eugen Hristev
2020-12-03 9:28 ` [PATCH 17/34] ARM: dts: at91: sama7g5: add pinctrl node Eugen Hristev
2020-12-03 9:28 ` [PATCH 18/34] ARM: dts: at91: sama7g5ek: add pinctrl for sdmmc1 and flx3 Eugen Hristev
2020-12-03 9:28 ` [PATCH 19/34] configs: sama7g5ek: enable mii command Eugen Hristev
2020-12-03 9:28 ` [PATCH 20/34] ARM: dts: sama7g5: add GMAC0 Eugen Hristev
2020-12-03 9:28 ` [PATCH 21/34] ARM: dts: sama7g5: add GMAC1 Eugen Hristev
2020-12-03 9:28 ` [PATCH 22/34] board: atmel: sama7g5ek: increase arp timeout and retry count Eugen Hristev
2020-12-03 9:28 ` [PATCH 23/34] configs: sama7g5ek: enable support for KSZ9131 Eugen Hristev
2020-12-03 9:28 ` [PATCH 24/34] configs: sama7g5ek: enable CCF Eugen Hristev
2020-12-03 9:28 ` [PATCH 25/34] ARM: dts: at91: sama7g5: add assigned clocks for sdmmc1 Eugen Hristev
2020-12-03 9:28 ` [PATCH 26/34] ARM: dts: at91: sama7g5: add node for sdmmc0 Eugen Hristev
2020-12-03 9:28 ` [PATCH 27/34] ARM: dts: at91: sama7g5ek: enable sdmmc0 with pinctrl Eugen Hristev
2020-12-03 9:28 ` [PATCH 28/34] board: atmel: sama7g5ek: clean-up header bootcommand Eugen Hristev
2020-12-03 9:28 ` [PATCH 29/34] configs: sama7g5: add mmc config for sdmmc0 Eugen Hristev
2020-12-03 10:38 ` Jaehoon Chung
2020-12-03 10:47 ` Eugen.Hristev at microchip.com
2020-12-03 11:11 ` Jaehoon Chung
2020-12-03 11:20 ` Eugen.Hristev at microchip.com
2020-12-03 21:45 ` Jaehoon Chung
2020-12-04 7:00 ` Eugen.Hristev at microchip.com
2020-12-06 22:15 ` Jaehoon Chung
2020-12-03 9:28 ` [PATCH 30/34] ARM: dts: at91: sama7g5: add flexcom1 and i2c subnode Eugen Hristev
2020-12-03 9:28 ` [PATCH 31/34] ARM: dts: sama7g5ek: add i2c1 bus and eeproms Eugen Hristev
2020-12-03 9:28 ` [PATCH 32/34] board: atmel: sama7g5ek: add support for MAC address retreival Eugen Hristev
2020-12-03 9:28 ` [PATCH 33/34] configs: sama7g5ek: add i2c and eeprom Eugen Hristev
2020-12-03 9:28 ` [PATCH 34/34] ARM: dts: sama7g5ek: fix TXC pin configuration Eugen Hristev
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20201203092850.7909-1-eugen.hristev@microchip.com \
--to=eugen.hristev@microchip.com \
--cc=u-boot@lists.denx.de \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox