[PATCH v2 10/21] sunxi: add support for R_I2C on H616

[Andre Przywara <andre.przywara@arm.com>]

On Mon, 11 Jan 2021 21:11:42 +0100
Jernej Skrabec <jernej.skrabec@siol.net> wrote:

> This port is needed for communication with PMIC. SPL uses it to set DRAM
> voltage on H616 boards.
> 
> Reviewed-by: Samuel Holland <samuel@sholland.org>
> Signed-off-by: Jernej Skrabec <jernej.skrabec@siol.net>

Compared the bits against the manual.

Reviewed-by: Andre Przywara <andre.przywara@arm.com>

Thanks!
Andre

> ---
>  arch/arm/include/asm/arch-sunxi/gpio.h | 1 +
>  board/sunxi/board.c                    | 4 ++++
>  2 files changed, 5 insertions(+)
> 
> diff --git a/arch/arm/include/asm/arch-sunxi/gpio.h b/arch/arm/include/asm/arch-sunxi/gpio.h
> index cdb7dbd5b8e5..de77bf638e21 100644
> --- a/arch/arm/include/asm/arch-sunxi/gpio.h
> +++ b/arch/arm/include/asm/arch-sunxi/gpio.h
> @@ -220,6 +220,7 @@ enum sunxi_gpio_number {
>  #define SUN8I_A23_GPL_R_TWI	3
>  #define SUN8I_GPL_R_UART	2
>  #define SUN50I_GPL_R_TWI	2
> +#define SUN50I_H616_GPL_R_TWI	3
>  
>  #define SUN9I_GPN_R_RSB		3
>  
> diff --git a/board/sunxi/board.c b/board/sunxi/board.c
> index 40fdd5da0477..14d31c719ece 100644
> --- a/board/sunxi/board.c
> +++ b/board/sunxi/board.c
> @@ -196,6 +196,10 @@ void i2c_init_board(void)
>  	clock_twi_onoff(5, 1);
>  	sunxi_gpio_set_cfgpin(SUNXI_GPL(8), SUN50I_GPL_R_TWI);
>  	sunxi_gpio_set_cfgpin(SUNXI_GPL(9), SUN50I_GPL_R_TWI);
> +#elif CONFIG_MACH_SUN50I_H616
> +	clock_twi_onoff(5, 1);
> +	sunxi_gpio_set_cfgpin(SUNXI_GPL(0), SUN50I_H616_GPL_R_TWI);
> +	sunxi_gpio_set_cfgpin(SUNXI_GPL(1), SUN50I_H616_GPL_R_TWI);
>  #else
>  	clock_twi_onoff(5, 1);
>  	sunxi_gpio_set_cfgpin(SUNXI_GPL(0), SUN8I_H3_GPL_R_TWI);