[RESEND v2 PATCH 12/16] arm: omap3: Compile lowlevel_init() function only when it is used

["Pali Rohár" <pali@kernel.org>]

Function lowlevel_init() is called only from cpu_init_crit() and this
function is wrapped into #if .. #endif section. So compile also
lowlevel_init() function under same #if condition.

Function cpy_clk_code() uses lowlevel_init symbol to get address where
go_to_speed code ends. As this symbol is not available anymore when
compiling with CONFIG_SKIP_LOWLEVEL_INIT, defines a new label
go_to_speed_end at the place where go_to_speed code ends.

Signed-off-by: Pali Roh?r <pali@kernel.org>
Reviewed-by: Lukasz Majewski <lukma@denx.de>
Acked-by: Pavel Machek <pavel@ucw.cz>
---
 arch/arm/mach-omap2/omap3/lowlevel_init.S | 6 +++++-
 1 file changed, 5 insertions(+), 1 deletion(-)

diff --git a/arch/arm/mach-omap2/omap3/lowlevel_init.S b/arch/arm/mach-omap2/omap3/lowlevel_init.S
index 2a05b5e521..4fa89418a1 100644
--- a/arch/arm/mach-omap2/omap3/lowlevel_init.S
+++ b/arch/arm/mach-omap2/omap3/lowlevel_init.S
@@ -45,7 +45,7 @@ ENDPROC(do_omap3_emu_romcode_call)
 ENTRY(cpy_clk_code)
 	/* Copy DPLL code into SRAM */
 	adr	r0, go_to_speed		/* copy from start of go_to_speed... */
-	adr	r2, lowlevel_init	/* ... up to start of low_level_init */
+	adr	r2, go_to_speed_end	/* ... up to start of go_to_speed_end */
 next2:
 	ldmia	r0!, {r3 - r10}		/* copy from source address [r0] */
 	stmia	r1!, {r3 - r10}		/* copy to   target address [r1] */
@@ -167,8 +167,11 @@ pll_div_add5:
 pll_div_val5:
 	.word CLSEL1_EMU_VAL
 
+go_to_speed_end:
 #endif
 
+#if !defined(CONFIG_SKIP_LOWLEVEL_INIT) && \
+	!defined(CONFIG_SKIP_LOWLEVEL_INIT_ONLY)
 ENTRY(lowlevel_init)
 	ldr	sp, SRAM_STACK
 	str	ip, [sp]	/* stash ip register */
@@ -187,6 +190,7 @@ ENTRY(lowlevel_init)
 	b	s_init
 
 ENDPROC(lowlevel_init)
+#endif
 
 	/* the literal pools origin */
 	.ltorg
-- 
2.20.1