[PATCH 2/2] mmc: fsl_esdhc_imx: Use esdhc_soc_data flags to set host caps

[Adam Ford <aford173@gmail.com>]

The Linux driver automatically can detect and enable UHS, HS200, HS400
and HS400_ES automatically without extra flags being placed into the
device tree.

Right now, for U-Boot to use UHS, HS200 or HS400, the extra flags are
needed in the device tree.  Instead, go through the esdhc_soc_data
flags and enable the host caps where applicable to automatically
enable higher speeds.

Suggested-by: Fabio Estevam <festevam@gmail.com>
Signed-off-by: Adam Ford <aford173@gmail.com>

diff --git a/drivers/mmc/fsl_esdhc_imx.c b/drivers/mmc/fsl_esdhc_imx.c
index e5814232a2..5088e78bb6 100644
--- a/drivers/mmc/fsl_esdhc_imx.c
+++ b/drivers/mmc/fsl_esdhc_imx.c
@@ -1305,8 +1305,29 @@ static int fsl_esdhc_init(struct fsl_esdhc_priv *priv,
 			val |= ESDHC_TUNING_CMD_CRC_CHECK_DISABLE;
 			esdhc_write32(&regs->tuning_ctrl, val);
 		}
-	}
 
+		/*
+		 * UHS doesn't have explicit ESDHC flags, so if it's
+		 * not supported, disable it in config.
+		 */
+		if (CONFIG_IS_ENABLED(MMC_UHS_SUPPORT))
+			cfg->host_caps |= UHS_CAPS;
+
+		if (CONFIG_IS_ENABLED(MMC_HS200_SUPPORT)) {
+			if (priv->flags & ESDHC_FLAG_HS200)
+				cfg->host_caps |= MMC_CAP(MMC_HS_200);
+		}
+
+		if (CONFIG_IS_ENABLED(MMC_HS400_SUPPORT)) {
+			if (priv->flags & ESDHC_FLAG_HS400)
+				cfg->host_caps |= MMC_CAP(MMC_HS_400);
+		}
+
+		if (CONFIG_IS_ENABLED(MMC_HS400_ES_SUPPORT)) {
+			if (priv->flags & ESDHC_FLAG_HS400_ES)
+				cfg->host_caps |= MMC_CAP(MMC_HS_400_ES);
+		}
+	}
 	return 0;
 }
 
-- 
2.32.0