[PATCH 1/2] ARM: imx: imx8mn-*-evk: use reset-gpios in phy node

Heiko Thiery
2022-02-23T09:49:01Z

To be in sync with the linux devicetree change the 'phy-reset-gpios' in
the fec node to 'reset-gpios' in the phy node. The PHY reset will be
done by the eth-phy-uclass driver while probing the PHY. This is ok
since it is done before probing the fec.

Signed-off-by: Heiko Thiery <heiko.thiery@gmail.com>
---
arch/arm/dts/imx8mn-evk.dtsi | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/arch/arm/dts/imx8mn-evk.dtsi b/arch/arm/dts/imx8mn-evk.dtsi
index fc2c7f1d44..ed865444da 100644
--- a/arch/arm/dts/imx8mn-evk.dtsi
+++ b/arch/arm/dts/imx8mn-evk.dtsi
@@ -53,7 +53,6 @@
pinctrl-0 = <&pinctrl_fec1>;
phy-mode = "rgmii-id";
phy-handle = <&ethphy0>;
- phy-reset-gpios = <&gpio4 22 GPIO_ACTIVE_LOW>;
fsl,magic-packet;
status = "okay";

@@ -64,6 +63,8 @@
ethphy0: ethernet-phy@0 {
compatible = "ethernet-phy-ieee802.3-c22";
reg = <0>;
+ reset-gpios = <&gpio4 22 GPIO_ACTIVE_LOW>;
+ reset-assert-us = <10000>;
vddio-supply = <&vddio>;

vddio: vddio-regulator {
--
2.30.2