[PATCH 0/5] mx6cuboxi: add eth support for SoMs revision 1.9+

[Josua Mayer <josua@solid-run.com>]

As of Revision 1.9 the SolidRun i.MX6 SoMs ship with a new PHY - an
ADIN1300 at address 1. This patchset carries many small parts to
facilitate proper operation of the ethernet port in U-Boot as well as
Linux:

1. Fix a compile error in the recently phy driver
2. Add support for configuring the clock output pins to the phy driver
3. update device-tree with support for the neew phy
4. support runtime patching of device-tree for Linux:
   enables only the phy node detected during boot, to avoid
   warning messages during boot.
5. finally enable the phy driver in the cuboxi defconfig

Josua Mayer (5):
  phy: adin: remove broken support for adi,phy-mode-override
  phy: adin: add support for clock output
  ARM: dts: imx6qdl-sr-som: add support for alternate phy addresses
  mx6cuboxi: fixup dtb ethernet phy nodes before booting an OS
  mx6cuboxi: enable driver for adin1300 phy

 arch/arm/dts/imx6qdl-sr-som.dtsi     | 17 +++++-
 board/solidrun/mx6cuboxi/mx6cuboxi.c | 78 +++++++++++++++++++++++++++
 configs/mx6cuboxi_defconfig          |  2 +
 drivers/net/phy/adin.c               | 80 ++++++++++++++++------------
 4 files changed, 141 insertions(+), 36 deletions(-)

-- 
2.34.1