[PATCH 3/3] arm: mvebu: turris_omnia: Specify VHV gpio for eFUSE programming

["Pali Rohár" <pali@kernel.org>]

VHV gpio is connected to MCU and only on updated board design. Without it
eFUSE programming does not work. Omnia MCU driver exports this GPIO to
U-Boot under name mcu_56 and only when it is supported by MCU. So U-Boot
fuse command refuse eFUSE programming on older board design when VHV gpio
is not available.

We tested that Armada 385 without connected VHV gpio can do eFUSE
programming but only for some bits and only sometimes - it is unstable.
And better to be disabled on older board design without VHV gpio support.

Signed-off-by: Pali Rohár <pali@kernel.org>
---
 configs/turris_omnia_defconfig | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/configs/turris_omnia_defconfig b/configs/turris_omnia_defconfig
index ba635feb44b2..01dee5472200 100644
--- a/configs/turris_omnia_defconfig
+++ b/configs/turris_omnia_defconfig
@@ -10,6 +10,8 @@ CONFIG_NR_DRAM_BANKS=2
 CONFIG_TARGET_TURRIS_OMNIA=y
 CONFIG_DDR_RESET_ON_TRAINING_FAILURE=y
 CONFIG_MVEBU_EFUSE=y
+CONFIG_MVEBU_EFUSE_VHV_GPIO="mcu_56"
+CONFIG_MVEBU_EFUSE_VHV_GPIO_ACTIVE_LOW=y
 CONFIG_ENV_SIZE=0x10000
 CONFIG_ENV_OFFSET=0xF0000
 CONFIG_ENV_SECT_SIZE=0x10000
-- 
2.20.1