[PATCH v2 5/5] imx8mn-var-som: adjust PHY reset gpios according to hardware configuration

[sbabic@denx.de]

> From: Hugo Villeneuve <hvilleneuve@dimonoff.com>
> For SOM with the EC configuration, the ethernet PHY is located on the
> SOM itself, and connected to the CPU ethernet controller. It has a
> reset line controlled via GPIO1_IO9. In this configuration, the PHY
> located on the carrier board is not connected to anything and is
> therefore not used.
> For SOM without EC configuration, the ethernet PHY on the carrier
> board is connected to the CPU ethernet controller. It has a reset line
> controlled via the GPIO expander PCA9534_IO5.
> The hardware configuration (EC) is determined at runtime by
> reading from the SOM EEPROM.
> To support both hardware configurations (EC and non-EC), adjust/fix
> the PHY reset gpios according to the hardware configuration
> read at runtime from the SOM EEPROM. This adjustement is done in
> U-Boot (OF_BOARD_FIXUP) and kernel (OF_BOARD_SETUP) device trees.
> Signed-off-by: Hugo Villeneuve <hvilleneuve@dimonoff.com>
Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,        Managing Director: Erika Unter  
HRB 165235 Munich,   Office: Kirchenstr.5, 82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic@denx.de
=====================================================================