[PATCH 2/2] board: ti: am64x: Switch to standard boot flow

[Roger Quadros <rogerq@kernel.org>]

Switch to using bootstd. Note with this change, we will stop using
distro_bootcmd and instead depend entirely on bootflow method of
starting the system up.

Signed-off-by: Roger Quadros <rogerq@kernel.org>
---
 board/ti/am64x/am64x.env        | 1 +
 configs/am64x_evm_a53_defconfig | 5 +++--
 include/configs/am64x_evm.h     | 2 --
 3 files changed, 4 insertions(+), 4 deletions(-)

diff --git a/board/ti/am64x/am64x.env b/board/ti/am64x/am64x.env
index 68e42222b7..efd736b99b 100644
--- a/board/ti/am64x/am64x.env
+++ b/board/ti/am64x/am64x.env
@@ -15,6 +15,7 @@ console=ttyS2,115200n8
 args_all=setenv optargs earlycon=ns16550a,mmio32,0x02800000 ${mtdparts}
 run_kern=booti ${loadaddr} ${rd_spec} ${fdtaddr}
 
+boot_targets=mmc1 mmc0 usb pxe dhcp
 boot=mmc
 mmcdev=1
 bootpart=1:2
diff --git a/configs/am64x_evm_a53_defconfig b/configs/am64x_evm_a53_defconfig
index 718ad176cb..43bfcf957a 100644
--- a/configs/am64x_evm_a53_defconfig
+++ b/configs/am64x_evm_a53_defconfig
@@ -31,8 +31,9 @@ CONFIG_SPL_SPI=y
 # CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
 CONFIG_SPL_LOAD_FIT=y
 CONFIG_SPL_LOAD_FIT_ADDRESS=0x81000000
-CONFIG_DISTRO_DEFAULTS=y
-CONFIG_BOOTCOMMAND="run envboot; run distro_bootcmd;"
+CONFIG_BOOTSTD_FULL=y
+CONFIG_BOOTSTD_DEFAULTS=y
+CONFIG_BOOTCOMMAND="run envboot; bootflow scan -lb"
 CONFIG_BOARD_LATE_INIT=y
 CONFIG_SPL_MAX_SIZE=0x180000
 CONFIG_SPL_HAS_BSS_LINKER_SECTION=y
diff --git a/include/configs/am64x_evm.h b/include/configs/am64x_evm.h
index 062102a610..d3d9eac8b6 100644
--- a/include/configs/am64x_evm.h
+++ b/include/configs/am64x_evm.h
@@ -10,8 +10,6 @@
 #define __CONFIG_AM642_EVM_H
 
 #include <linux/sizes.h>
-#include <config_distro_bootcmd.h>
-#include <env/ti/mmc.h>
 #include <asm/arch/am64_hardware.h>
 #include <env/ti/k3_dfu.h>
 
-- 
2.34.1