[PATCH] xilinx: zynqmp: Allow multiboot environment write even in saved environment

[Kory Maincent <kory.maincent@bootlin.com>]

Once the environment was saved, we could not retrieve information about
the multiboot image used. When dealing with firmware updates, this
information is necessary alongside the saved environment.

Move the multiboot environment set operation before the saved environment
check to ensure this information is always available.

Signed-off-by: Kory Maincent <kory.maincent@bootlin.com>
---
 board/xilinx/zynqmp/zynqmp.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/board/xilinx/zynqmp/zynqmp.c b/board/xilinx/zynqmp/zynqmp.c
index f370fb7347a..16292ed1c7e 100644
--- a/board/xilinx/zynqmp/zynqmp.c
+++ b/board/xilinx/zynqmp/zynqmp.c
@@ -519,6 +519,10 @@ int board_late_init(void)
 	usb_ether_init();
 #endif
 
+	multiboot = multi_boot();
+	if (multiboot >= 0)
+		env_set_hex("multiboot", multiboot);
+
 	if (!(gd->flags & GD_FLG_ENV_DEFAULT)) {
 		debug("Saved variables - Skipping\n");
 		return 0;
@@ -531,10 +535,6 @@ int board_late_init(void)
 	if (ret)
 		return ret;
 
-	multiboot = multi_boot();
-	if (multiboot >= 0)
-		env_set_hex("multiboot", multiboot);
-
 	if (IS_ENABLED(CONFIG_DISTRO_DEFAULTS)) {
 		ret = boot_targets_setup();
 		if (ret)
-- 
2.34.1