[PATCH v2 1/2] spi: sunxi: fix CDR2 calculation

[Michael Walle <mwalle@kernel.org>]

The CDR2 divider calculation always yield a frequency greater than the
requested one. Use DIV_ROUND_UP() to keep the frequency equal or below
the requested one. This way, we can also drop the "if div > 0" check
because we know for a fact that div cannot be zero.

FWIW, this aligns the CDR2 calculation with the linux driver.

Suggested-by: Andre Przywara <andre.przywara@arm.com>
Signed-off-by: Michael Walle <mwalle@kernel.org>
---
 drivers/spi/spi-sunxi.c | 11 ++++-------
 1 file changed, 4 insertions(+), 7 deletions(-)

diff --git a/drivers/spi/spi-sunxi.c b/drivers/spi/spi-sunxi.c
index bfb402902b8..f110a8b7658 100644
--- a/drivers/spi/spi-sunxi.c
+++ b/drivers/spi/spi-sunxi.c
@@ -233,7 +233,7 @@ err_ahb:
 static void sun4i_spi_set_speed_mode(struct udevice *dev)
 {
 	struct sun4i_spi_priv *priv = dev_get_priv(dev);
-	unsigned int div;
+	unsigned int div, div_cdr2;
 	u32 reg;
 
 	/*
@@ -259,15 +259,12 @@ static void sun4i_spi_set_speed_mode(struct udevice *dev)
 	 */
 
 	div = DIV_ROUND_UP(SUNXI_INPUT_CLOCK, priv->freq);
+	div_cdr2 = DIV_ROUND_UP(div, 2);
 	reg = readl(SPI_REG(priv, SPI_CCR));
 
-	if ((div / 2) <= (SUN4I_CLK_CTL_CDR2_MASK + 1)) {
-		div /= 2;
-		if (div > 0)
-			div--;
-
+	if (div_cdr2 <= (SUN4I_CLK_CTL_CDR2_MASK + 1)) {
 		reg &= ~(SUN4I_CLK_CTL_CDR2_MASK | SUN4I_CLK_CTL_DRS);
-		reg |= SUN4I_CLK_CTL_CDR2(div) | SUN4I_CLK_CTL_DRS;
+		reg |= SUN4I_CLK_CTL_CDR2(div_cdr2 - 1) | SUN4I_CLK_CTL_DRS;
 	} else {
 		div = fls(div - 1);
 		/* The F1C100s encodes the divider as 2^(n+1) */
-- 
2.39.2