* [U-Boot] I2C1 is not working in U-boot, When I2C2 pins are config as GPIO in MPC8313 board
@ 2009-03-20 14:03 rudresh
0 siblings, 0 replies; only message in thread
From: rudresh @ 2009-03-20 14:03 UTC (permalink / raw)
To: u-boot
We have custom board based on MPC8313ERDB processor. This processor is having
silicon revision 1.0.
We have RTC & ADC connected over i2c1. Also, We are using GPIO pins muxed
with i2c2 in GPIO mode.
The problem is, when i configure these muxed gpio pins in GPIO mode, my ADC
& RTC is not working.
Content of SICRL & SICRH Register at this Condition were as follows :-
SICRL : 33fc0800
SICRH : 0030c003
We disabled GPIO mode for GPIO pins muxed with i2c2 and found ADC & RTC over
I2C1 working fine.
Content of SICRL & SICRH Register at this Condition were as follows :-
SICRL :- 33fc0800
SICRH :- 0000c003
Thanks
Rudresh
--
View this message in context: http://www.nabble.com/I2C1-is-not-working-in-U-boot%2C-When-I2C2-pins-are-config-as-GPIO-in-MPC8313-board-tp22620921p22620921.html
Sent from the Uboot - Users mailing list archive at Nabble.com.
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2009-03-20 14:03 UTC | newest]
Thread overview: (only message) (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2009-03-20 14:03 [U-Boot] I2C1 is not working in U-boot, When I2C2 pins are config as GPIO in MPC8313 board rudresh
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox