From mboxrd@z Thu Jan  1 00:00:00 1970
From: =?utf-8?B?6b2Q5bCn?= <qiyao@bit.edu.cn>
Date: Mon, 20 Sep 2004 13:45:38 +0800
Subject: [U-Boot-Users] I can not drive CS8900 on mx1ads by U-boot-1.1.1-imx1
Message-ID: <295658822.30249@eyou.net>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

Hi
    I have downlodaded the u-boot-1.1.1 and patch for imx1,and i have cross-compiled them successfully!.
    Now ,the u-boot can work well on mx1ads, but the i can not control ethcad cs8900 very well.i can not read the id of cs8900.I have ported the blob to mx1ads ,and i can get the id of cs8900 .now ,i just copy the code in blob to u-boot to get the id of cs8900 ,but i am failed .I do not know why .
    the code related to is as follows :
    //set CS4U 
    *(volatile unsigned long*)(0x00220020)  = 0x00000F00;
    //set CS4L control register
    *(volatile unsigned long*)(0x00220024)  = 0x80001501;

    //set  the GPIO muxing to use Chip Select 4
    *(volatile unsigned long*)(0x0021C020) &= 0xFF3FFFFF;
    *(volatile unsigned long*)(0x0021C038) &= 0xFF3FFFFF;
    //the irq is connect to  GPIO pin to PortC pin 17
    *((volatile unsigned long* ) 0x0021c220)&=~0x00020000;
    *((volatile unsigned long*)  0x0021c238)&=~0x00020000;
    //send the base address of cs8900 on the ADD Bus 
     c = *(volatile unsigned char *)(0x15000300);
     CS8900_PPTR = regno;
     printf("CS8900_PDATA = %x\n",CS8900_PDATA);

the result is always 0x5555 or 0x5575,i do not know why,these codes above can work well in blob.
 I am looking forward your reply,thank ahead!

       Beijing Institute of Technology   Qiyao
       E-mail : qtopia at 126.com
       msn: qiyaobit at hotmail.com