[U-Boot] [PATCH v8 2/8] ARM: socfpga: Add default FPGA bitstream fitImage for Arria10 SoCDK

[Dalon L Westergreen <dalon.westergreen@linux.intel.com>]

On Wed, 2019-02-13 at 17:10 +0100, Marek Vasut wrote:
> On 2/13/19 3:18 PM, tien.fong.chee at intel.com wrote:
> > From: Tien Fong Chee <tien.fong.chee@intel.com>
> > 
> > Add default fitImage file bundling FPGA bitstreams for Arria10.
> > 
> > Signed-off-by: Tien Fong Chee <tien.fong.chee@intel.com>
> > 
> > ---
> > 
> > changes for v8
> > - Changed the FPGA node name to fpga-core and fpga-periph for both core and
> >   periph bitstreams respectively.
> > ---
> >  board/altera/arria10-socdk/fit_spl_fpga.its | 39
> > +++++++++++++++++++++++++++++
> >  1 file changed, 39 insertions(+)
> >  create mode 100644 board/altera/arria10-socdk/fit_spl_fpga.its
> > 
> > diff --git a/board/altera/arria10-socdk/fit_spl_fpga.its
> > b/board/altera/arria10-socdk/fit_spl_fpga.its
> > new file mode 100644
> > index 0000000..8ce175b
> > --- /dev/null
> > +++ b/board/altera/arria10-socdk/fit_spl_fpga.its
> > @@ -0,0 +1,39 @@
> > +// SPDX-License-Identifier: GPL-2.0
> > + /*
> > + * Copyright (C) 2019 Intel Corporation <www.intel.com>
> > + *
> > + */
> > +
> > +/dts-v1/;
> > +
> > +/ {
> > +	description = "FIT image with FPGA bistream";
> > +	#address-cells = <1>;
> > +
> > +	images {
> > +		fpga-core at 1 {
> > +			description = "FPGA core bitstream";
> > +			data = /incbin/("../../../ghrd_10as066n2.core.rbf");
> > +			type = "fpga";
> > +			arch = "arm";
> > +			compression = "none";
> > +			load = <0x400>;
> 
> Is the load address required ?
> 
> > +		};
> > +
> > +		fpga-periph at 2 {
> > +			description = "FPGA peripheral bitstream";
> > +			data = /incbin/("../../../ghrd_10as066n2.periph.rbf");
> > +			type = "fpga";
> > +			arch = "arm";
> > +			compression = "none";
> > +		};
> > +	};
> > +
> > +	configurations {
> > +		default = "config-1";
> > +		config-1 {
> > +			description = "Boot with FPGA early IO release config";
> > +			fpga = "fpga-periph at 2", "fpga-core at 1";
> 
> Don't you need to load the core first ?

No, the periphery is first.  This brings up the dram and i/o.

--dalon

> 
> > +		};
> > +	};
> > +};
> > 
> 
>